Abstract:In some data acquisition applications, the acquisition data should be stored on the storage devices like hard disks for post-analysis use. In those cases, real-time and high data transfer rate are two key points for the design of such data storage systems. After the I/O bottleneck of conventional storage system structure is analyzed, this paper presents a new architecture for high-speed sustained data recording system used in data acquisition systems, aiming to improve the data transfer rate without data loss. Unlike those conventional applications that SCSI disks are chosen as the storage devices, IDE disks are used in the design because of their lower price. A real-time storage controller of IDE hard disks implemented by field programmable gate array (FPGA) for such acquisition data storage applications is also presented. It is designed to write the hard disk directly without the intervention of the host so that the utilization of host resource and latency are reduced, consequently satisfy the real-time requirement. Based on the timing diagram got by logic analyzer in our design, the limitation of data transfer rate is analyzed to help us decide the size of the buffer which acts as a speed-match module between the disk in burst transfer mode and the sustained source acquisition data stream. The proposed architecture and implementation approaches can be adapted in many applications where real-time and high data transmission rate are required.

IDE Hard Disk Interface Card realized by FPGA

New Realization Method of IDE Interface

Design of the DDR SDRAM Controller Integrated by the Data Intensive Computing Architecture

Design of Interface of Astronautic Camera Controller Based on FPGA

The Implementation Of An Fpga-Based Storage Controller For Data Acquisition System

Implementation of SD Mode of Secure Digital Card Interface Based on FPGA

Design and development of a computer interface experimental platform bawd on advanced FPGA

Design and Implementation of Serial ATA Pbysical Layer on FPGA.

Method of Implementation of ATA-RAID Based on Embedded System

Design of PXI Express Interfacing Based on FPGA

Design and Implementation of FPGA Based High-Speed Bus for Control System

Design of High-speed Data Transmission System based on PCI Express interface

Design for HW/SW Co-Testing Based on FPGA

The design of board worked in Initiator mode of PCI bus based on PCI9054

Fpga Implementation Of Interface For Real-Time Recording/Reading Of High-Speed Continuous Data Stream

The Realization of PCI Communications Based on the FPGA and PCI9656

Design and Implementation of High Integrated AM80486 CPU Based on PCI Controller

NetStorageFPGA—A prototyping platform for building high-performance transmission and storage systems using Field Programmable Gate Array (FPGA) hardware

Design and implementation of a new FPGA architecture

Design of PXI-1553B module based on FPGA

Design of High-speed Solid State Drive in FPGA