Controlled Release of Albumin from Biodegradable Poly(dl-Lactide) Cylinders

XC ZHANG,UP WYSS,D PICHORA,B AMSDEN,MFA GOOSEN
DOI: https://doi.org/10.1016/0168-3659(93)90095-m
IF: 11.467
1993-01-01
Journal of Controlled Release
Abstract:A cylindrical monolithic matrix release device was made by extruding an albumin suspension in a poly(dl-lactide) acetone solution, to form rods. After coating with pure poly(dl-lactide), the rods, with 10% to 30% albumin loading, were cut into specific lengths (0.5–4 cm). The release properties of protein from short cylinders (0.5–1 cm, 30% loading) into saline were found to be primarily diffusion controlled. Albumin was released from channels which were formed by voids originally present and voids left by released albumin, all connected to the uncoated ends of the cylinder. On the other hand, the release of albumin from longer devices (2–4 cm, 30% loading) was controlled by a combination of diffusion and osmotic pressure. The effect of device manufacturing factors (i.e., poly(dl-lactide) solution concentration and polymer molecular weight), on the release properties was not found to be significant. When the loading was reduced from 30% to 10%, for the short cylinders, the release mechanism changed from diffusion controlled to osmotic pressure controlled. It was possible to adjust the release rates by cutting the cylinders into different lengths. For devices of 0.5 to 4 cm in length and 30% loading, the duration of release went from 200 to 800 hours, respectively.
What problem does this paper attempt to address?