Solvent Induced Phase Separation in a Nylon 6-B-polyimide-b-nylon 6 Triblock Copolymer

Qiang Fu,Bryan P. Livengood,Ching-Chang Shen,Fu-Le Lin,Weihan Li,Frank W. Harris,Stephen Z. D. Cheng,Benjamin S. Hsiao
DOI: https://doi.org/10.1007/s10965-006-0001-7
IF: 3.061
1997-01-01
Journal of Polymer Research
Abstract:A series of new nylon 6-b-polyimide-b-nylon 6 (triblock) copolymers have been synthesized via condensation polymerization of the polyimide component and anionic polymerization of the nylon 6 component. The polyimide component is prepared from bisphenol-A dianhydride (BisA-DA) and bisaniline-P diamine (BisP) with end-capped functional groups. After the polyimides are dissolved in caprolactam, the nylon 6 anionic polymerization is initiated by the functional groups of the polyimides. The triblock copolymers can be dissolved in both m-cresol and 1,6-hexanediol. Of the two components present in the copolymers, nylon 6 crystallizes partially and BisA-DA/BisP is amorphous. Based on differential scanning calorimetry, dynamic mechanical analysis, wide angle X-ray diffraction, small angle X-ray scattering and transmission electron microscopy experiments, the copolymer films prepared from the 1,6-hexanediol solution are phase separated. The BisA-DA/Bis P and the nylon 6 components show little miscibility in the inter-lamellar amorphous region. However, in the films prepared from the m-cresol solution both components are largely miscible in the inter-lamellar amorphous region. This is due to the different solvation power of the two solvents with respect to the polyimide and nylon 6.
What problem does this paper attempt to address?