Abstract:Stack-induced pressure differences cause various problems in high-rise buildings. In particular, the reopening problem, which involves difficulty in closing elevator doors, and which arises from large stack-induced pressure differences across the elevator shafts, can be especially troublesome. This paper performs an experimental study that uses a full-scale mock-up to evaluate the effects of pressure differences on the functioning of elevator doors. Pressure distribution measurements were taken and simulations were performed for 25 actual buildings to analyze problems related to pressure differences. The analysis shows that the threshold value for malfunctions is different from the previously suggested threshold of 25 Pa. After a theoretical study on the principles governing the operation of elevator doors in an elevator shaft, experiments were performed with a full-scale mock-up that is capable of simulating four airflow directions associated with the stack effect, the reverse stack effect, and the location of the elevator car at either the uppermost or the lowermost floor. The results of the experiments, which were conducted with various conditions for the direction of the stack effect, location of the elevator car, and door type, show that the reopening problem of elevator doors occurs when there is a pressure difference of approximately 40 Pa. It is observed that the problem of elevator door malfunction is more severe at the lower floors during the heating mode and at the higher floors during the cooling mode.

Analysis of Elevator Door Motor Rotor-Stuck Status and Restriction of Door-Closing Force

Research On The Vertical Dynamics Of High-Speed Elevator System - Art. No. 60400v

The design and application of brushless DC motor on the control system of elevator door

Development of Temperature-Sensed Automatic Door Closer Based on SMA Actuator

The design of permanent magnet variable-frequency door-motor with one-driver dual control

Research on Position Sensor Magnetic Encoder Based on the Elevator Door Machine Servo System

Research on the Design of Driver Control Unit for Door Motor System

Design of a High-Speed Long-Stroke Heavy-Load Magnetically Suspended Door System

Magnetic field and performance analysis of a tubular permanent magnet linear synchronous motor applied in elevator door system

Analysis of the energy and safety critical traction parameters for elevators

Optimized control design of sliding plug door for high-speed EMU

Psoc Control of a LIM-Driven Elevator Door

Simulation for Electromechanical Coupling Model of Elevator Systems

Calculation of Friction Coefficient of Elevator Door System

Simulation and Optimization Research of the Actuator for Soft-Close Automatic Car Doors

A Novel Tubular Permanent Magnet Linear Synchronous Motor Used for Elevator Door

DTC control system for high-rise building elevator door motor

A novel control strategy for vibration reduction in the permanent magnet motor drive system with eccentric load

Design Of Comprehensive Motor Protector Based On Improved Sliding-Window Iterative Dft Algorithm

Experimental study on elevator door reopening problems caused by stack induced pressure differences across the elevator door in buildings

Study on Performance of Door Compound Hinge with Hold Regulator