Abstract:The characteristics of anaerobic phosphorus release and anoxic phosphorus uptake were investigated in sequencing batch reactors using denitrifying phosphorus removing bacteria (DPB) sludge. The lab-scale experiments were accomplished under conditions of various nitrite concentrations (5.5, 9.5, and 15 mg/L) and mixed liquor suspended solids (MLSS) (1844, 3231, and 6730 mg/L). The results obtained confirmed that nitrite, MLSS, and pH were key factors, which had a significant impact on anaerobic phosphorus release and anoxic phosphorus uptake in the biological phosphorous removal process. The nitrites were able to successfully act as electron acceptors for phosphorous uptake at a limited concentration between 5.5 and 9.5 mg/L. The denitrification and dephosphorous were inhibited when the nitrite concentration reached 15 mg/L. This observation indicated that the nitrite would not inhibit phosphorus uptake before it exceeded a threshold concentration. It was assumed that an increase of MLSS concentration from 1844 mg/L to 6730 mg/L led to the increase of denitrification and anoxic P-uptake rate. On the contrary, the average P-uptake/N denitrifying reduced from 2.10 to 1.57 mg PO43−-P/mg NO3−-N. Therefore, it could be concluded that increasing MLSS of the DEPHANOX system might shorten the reaction time of phosphorus release and anoxic phosphorus uptake. However, excessive MLSS might reduce the specific denitrifying rate. Meanwhile, a rapid pH increase occurred at the beginning of the anoxic conditions as a result of denitrification and anoxic phosphate uptake. Anaerobic P release rate increased with an increase in pH. Moreover, when pH exceeded a relatively high value of 8.0, the dissolved P concentration decreased in the liquid phase, because of chemical precipitation. This observation suggested that pH should be strictly controlled below 8.0 to avoid chemical precipitation if the biological denitrifying phosphorus removal capability is to be studied accurately.

Effects of phosphorus release amount and temperature on denitrifying phosphorus removal in a two-sludge system

Influence of Carbon Source and Temperature on the Denitrifying Phosphorus Removal Process

Effects of Temperature on Denitrifying Phosphorus Removal in Enhanced Biological Phosphorus Removal (EBPR) Process

DENITRIFYING PHOSPHORUS ACCUMULATION CHARACTERISTICS OF A~2/O EBPR PROCESS UNDER LOW TEMPERATURE CONDITION

Effects of temperature and pH on nitrogen and phosphorus removal by activated sludge

Study on Factors Influencing the Phosphorus Release of Denitrifying Phosphorus Removal Sludge in Anaerobic Condition

Effect of Temperature on Denitrifying Phosphorus Removal by A/O Process

Study on influence of temperature and MLSS on denitrifying phosphorus removal system

Effect of Temperature and Denitrifying Phosphorus on Nitrogen and Phosphorous Removal in SBMBBR

Effects of Different External Carbon Sources and Electron Acceptors on Interactions Between Denitrification and Phosphorus Removal in Biological Nutrient Removal Processes

Influence of MLSS, Ph, and NO-2 -N Concentration on Denitrifying Phosphorus Removal

Effect of Electron Acceptors and MLSS on Denitrifying Phosphorus Removal

Influence of pH on denitrifying phosphorus removal using nitrite as electron acceptor

Effect of temperature and external carbon source on simultaneous nitrogen and phosphorus removal

Effect of nitrate concentration on phosphorus removal in denitrifying dephosphatation system

[Effects of Solid Retention Time on the Phosphorus Removal and Nitrosation Granules System]

Effect of temperature and COD on ability of denitrifying phosphorus removal in SBR

Effects of low temperature on sludge settleability and nutrients removal performance treating domestic wastewater

Characteristics of anoxic phosphors removal in sequence batch reactor

Influence of carbon source on the denitrifying phosphorus removal in A~2O process at low temperature

Effect of Environmental Factors on the Efficiency of Denitrifying Phosphorus Removal Bacteria