Preparation and Properties of Conductive Silver-Coated PET Fibers

JIAO Hong-juan,GUO Hong-xia,LI Yong-qing,YUAN Yan-xing,WANG Qun
DOI: https://doi.org/10.3969/j.issn.1006-3080.2006.02.011
2006-01-01
Abstract:Silver-coated PET fibers used as the conductive filler of conductive polymer composites were successfully prepared by electroless silver plating on the fibers.The influences of the concentration of(ammonia),stabilizing agent and bath loading on silver plating were investigated.The results indicate that it's favorable to the electroless silver plating,when the volume fraction of ammonia water φ=0.10.The weight of coated silvers and silver nitrate usage are increased by adjustment of bath loading.Adding stabilizing agent in the bath is helpful to prevent the plating from decomposing.However,it results in discontinuous silver coating layer.The volume electrical resistivity of the silver-coated PET fibers reaches to(3.35)×10~(-3) Ω·cm.,and the electrical resistivity of the conductive rubber with the as-prepared silver-coated PET fibers as filleris 1.54×10~(-1) Ω·cm when the mass fraction of PET w=0.40.
What problem does this paper attempt to address?