Abstract:The emerging upward shield method (USM) for constructing vertical shafts has been used in various projects, including the Midosuji utility tunnel in Japan. A scaled-down model testing system, featuring a geometric similarity ratio of 1:30, was developed specifically for studying the USM. This system incorporates sand inflow control, propulsion control, data acquisition, and water level control. It facilitates detailed observation and recording of parameters such as vertical displacement of surface soil layers, support force at the excavation face, and earth pressure within the model box. Consequently, it enables investigation into the excavation face instability process, modes, and the formation and evolution of the soil arch zone above the excavation face during upward shield tunneling. Additionally, through the application of particle image velocimetry (PIV) technology and GeoPIV-RG software v1.1, quantitative analysis of soil displacement fields during excavation face instability is conducted, capturing microscopic displacements and deformations of soil planes. This approach more accurately elucidates the accuracy of understanding the dynamic response of soil. Pre-test research using the model testing system explores the variation patterns of excavation face load displacement, vertical earth pressure within the failure zone, surface displacement, and internal soil displacement during the instability process. Analysis reveals that excavation face load variation typically progresses through three stages: rapid growth, slow growth, and descent. Moreover, vertical earth pressure shifts upward in tandem with excavation face displacement, while overall surface displacement initially shows slight settlement followed by accelerated uplift.

Research of Blasting Centrifugal Modeling System and Basic Experiment

Development and Prospect for Centrifugal Blasting Modeling

Centrifuge Modelling of Blast Effects in Dry Sand: Coriolis Effect and Soil Arching

Experimental Research on Heat Conduction and Temperature Control Method in the Chamber of Large-Scale Geotechnical Centrifuge

Centrifugal modeling of blast-induced response of tunnel

Centrifugal model testing study of explosion-induced craters and propagation of ground shock in clay

CENTRIFUGAL MODEL TESTS FOR RESPONSES OF SHALLOW-BURIED UNDERGROUND STRUCTURES UNDER SURFACE BLASTING

Centrifugal Modeling of Blast-Induced Response for Shallow-Buried Tunnel

BOUNDARY EFFECTS IN BLASTING CENTRIFUGE MODELING

Numerical Simulation of Dynamic Damage and Stability of a Bedding Rock Slope under Blasting Load

Validation study on numerical simulation of RC response to close-in blast with a fully coupled model

Model Design and Application for Excavation Face Stability in Upward Shield Tunneling

Development of Geotechnical Centrifuge ZJU400 and Performance Assessment of Its Shaking Table System

Physical Model Test on the Deformation Behavior of an Underground Tunnel Under Blasting Disturbance

In-Flight Simulation of the Excavation of Foundation Pit in Centrifuge Model Tests

Centrifuge Modelling Of Active Earth Pressures

Dynamic Centrifuge Model Tests on an Unconfined Soil Foundation

Experiments and simulation of block motion in underwater bench blasting

Study on the crack propagation behaviour of eccentric uncoupled blasting in a deep-level rock mass

Study on Blasting Vibration Simulating Darthquake

Damage Analysis of Concrete Structure under Multidirectional Shaped Charge Blasting Using Model Experiment and Ultrasonic Testing