Abstract:NOx and SO2 are the main air pollutants emitted from the coal-fired combustors. Since the typical combination of selective catalytic reduction (SCR) and we flue gas desulfurization (WFGD) is not suitable for some of industrial flue gas treatment due to their unsuitable temperature window and limited retrofitting space, new technologies must be developed. This paper proposes an effective we method for simultaneous removal of NOx and SO2. The insoluble NO was first oxidized into NO2 by ozone, and then NO2 together with SO2 were both absorbed in one we wash tower. To further improve NO2 removal efficiency, a new kind of additive was proposed and tested. Effects of various influence factors, such as additive concentration, residence time in the wash tower, liquid/gas ratios, initial NO/SO2/O-2 concentration and slurry pH value, were carefully evaluated in a home-designed experimental platform. Results indicated that the NOx removal efficiency was positively correlated with the increasing the additive concentration, while the maximum denitration and desulfurization efficiency were more than 95% and 86%. The NOx removal efficiency was enhanced with the increasing residence time and liquid/gas ratios. The alkaline environment was verified to be beneficial for the simultaneous absorption process. The exiting O-2 in flue gas would not consume additives, and the denitration and desulfurization efficiency were insensitive to the initial NO and SO 2 concentration as well. Only 2% decrease of the denitration efficiency was observed after 300 mins stability test, while the desulfurization efficiency kept > 98%. With the characterizations of Ion Chromatograph (IC), NO2-, NO3- and SO42- were detected as the main absorption by-products anions, whereas NO2- accumulation would inhibit the overall NOx removal. Finally, the mechanism of simultaneous removal of SO2 and NO using the novel liquid phase catalyst was proposed and discussed.

STUDY ON THE ABSORPTION PROPERITES OF NO2 IN LIME-STONE SLURRY

Simultaneous Absorption of NOx and SO2 in Oxidant‐enhanced Limestone Slurry

Nitrogen Oxide Absorption and Nitrite/nitrate Formation in Limestone Slurry for WFGD System

Simultaneous Absorption of SO2 and NO from Flue Gas with KMnO4/CaCO3 Slurry

Research on Simultaneous Desulfurization and Denitrification by Ozone Oxidation Integrated with Chemical Scrubber:Theoretical Analysis of SOx and NOx Absorption Properties of Limestone Slurry

Absorption of NOx from flue gas with alkaline aqueous solution combined with gas-phase oxidation of NO using ozone

Study on NO_x Absorption Into(NH_4)_2SO_3 Solution in the Process of Ammonia-based Wet Flue Gas Desulfurization

Effect of Additive Agents on the Simultaneous Absorption of No2 and So2 in the Calcium Sulfite Slurry

Study on NOx Absorption Into(NH4)2SO3 Solution in the Process of Ammonia-based Wet Flue Gas Desulfurization

Absorption of NO2 into Na2S Solution in a Stirred Tank Reactor

Wet Oxidation and Absorption Procedure for NOx Removal

Kinetics of NOx absorption into (NH4) 2SO3 solution in an ammonia-based wet flue gas desulfurization process

Enhanced absorption process of NO2 in CaSO3 slurry by the addition of MgSO4

Studies on the absorption of nitric oxide by ferrous cysteine solution

Study On The Absorption Rate Of No With Aqueous Ferrous Cysteine Solutions In A Double-Stirred Cell

Experiment on Simultaneous Absorption of NO and SO2 from Sintering Flue Gas by Oxidizing Agents of KMnO4/NaClO

Integrated Tests for Removal of Nitric: Oxide with Iron Thiochelate in Wet Flue Gas Desulfurization Systems

Effect of gas-liquid phase compositions on NO2 and NO absorption into ammonium-sulfite and bisulfite solutions

Simultaneous Absorption of SO2 and NO from Flue Gas with CaCO3 and Liquid Phase Oxidation

Experimental Study on Additive Enhanced Limestone Wet Flue Gas Desulfurization

A Superior Liquid Phase Catalyst for Enhanced Absorption of NO2 Together with SO2 after Low Temperature Ozone Oxidation for Flue Gas Treatment