Abstract:The microstructure of poly(vinyl alcohol) films formed during the solution drying process significantly influences their tensile ductility and optical transmittance. However, the "skin-core" structure of the dried PVA film is very obvious since the PVA solution dries extremely fast at a relatively low initial concentration (C-0). Herein, we propose a strategy to reduce the evaporation rate through the incorporation of plasticizer-type additives. For this purpose, urea and diethanolamine (DEA) were selected as the compound additives. On the one hand, the solubility of urea in water was improved by DEA because DEA is a good solvent for urea. On the other hand, more intermolecular hydrogen bonds were formed between the primary amine groups on urea and the hydroxyl (-OH) groups on PVA. The formation of PVA-plasticizer hydrogen bonding networks significantly prolonged the deceleration drying period and slowed down the drying process of the solution. In addition, the reduction in the content of single hydrogen-bonded water also favored the acquisition of a homogeneous structure. When the content of the urea/DEA compound additives was over 10%, the "skin-core" structure was suppressed. The structural changes in films have had an impact on both mechanical and optical performances. The fracture strain of the modified PVA film reaches 448.2%, and the average light transmittance in the visible range reaches 97.8% when the content of the compound additive is 20% of the PVA mass. These values are much higher than those of the control film, which are 9.2 and 92.2%, respectively. This study enhances comprehension of the film-forming mechanism and structural changes in PVA/H2O/plasticizer systems, offering theoretical insights for improved industrial processing.

Study on Properties and Structure of Urea Denaturation Soy Protein Plastics

Mechanical properties of soybean protein plastics modified by plasticizing and denaturation

Properties and Structure of Soy Protein Plastic with Different Formamide Contents

Water Resistance of Soybean Protein Plastics Modified by Plasticizing and Denaturation

Multi-dimensional analysis of heat-induced soybean protein hydrolysate gels subjected to ultrasound-assisted pH pretreatment

The Effect of Processing Technology on the Property of Soy Protein Plastics

Effects of Different Denaturants on Properties and Performance of Soy Protein-Based Adhesive

Thermal properties and adhesion strength of modified soybean storage proteins

Structure and Properties of Urea-Plasticized Starch Films with Different Urea Contents

Studies on Properties of Pva Film Plasticized with Mixture of Urea/Ethanolamine

Studies on the Properties of Poly(vinyl Alcohol) Film Plasticized by Urea/ethanolamine Mixture

Processing and characterization of biodegradable soy plastics: Effects of crosslinking with glyoxal and thermal treatment

Structure and properties of soy protein/alumina hydrate nanocomposites fabricated via in situ synthesis

INFLUENCE OF COMPLEX PLASTICIZERS CONTAINING GLYCEROL AND SORBITOL ON THE SOYPROTEIN PLASTIC CHARACTERISTICS

Surface Properties and Emulsification Behavior of Denatured Soy Proteins

Robust Soy Protein Films Obtained by Slight Chemical Modification of Polypeptide Chains

Suppression of the Skin-Core Structure of Poly(vinyl Alcohol) Films by Adding Urea/Diethanolamine to Improve the Mechanical and Optical Properties

Research on the Preparation and Properties of Soybean Protein Gel

A Study on Physical and Chemical Properties ofSoy Protein Hydrolysates

The Effect of Carboxyl Group Content on Water Uptake Capacity and Tensile Properties of Functionalized Soy Protein-Based Superabsorbent Plastics

Understanding the Effect of Urea on the Phase Transition of Poly(n-Isopropylacrylamide) in Aqueous Solution by Temperature-Dependent Near-Infrared Spectroscopy.