Abstract:The strength of prestressed steel strands has developed towards high strength, increasing from 1860 MPa to over 2200 MPa. The stress in the prestressed anchorage zone is more concentrated and complex, and the anchor plates for dispersed loads need to be optimized in design. This article proposes a design scheme for adding a middle pressure-bearing step based on the existing anchor plate and then establishes a 1/4 model of the concrete anchoring area of the anchor plate for finite element analysis. Based on the theory of the strut-and-tie model, the position of the middle pressure-bearing step is determined according to the maximum angle of the strut-and-tie model. Then, carry out force transfer tests in the anchorage zone for verification. The research results indicate that after adding a middle pressure bearing step to the anchor plate, the angle between the strut-and-tie model in the anchorage zone increases, and the bearing capacity improves. The position of the middle pressure-bearing step in the anchor plate is different, and the angle between the strut-and-tie models is different. According to the middle step position parameter, λ (the ratio of the effective width of the middle step to the distance from the middle step to the end face of the anchor plate) is 0.533 to optimize the anchor plate, and the bearing capacity of its anchorage zone is relatively high. The main tensile and main compressive stresses of the anchor plate after optimization increased by 6.2% and 5.74%, respectively, compared to the anchor plate before optimization. The main tensile stress of the spiral reinforcement under the anchor plate decreased by 0.59%, the main compressive stress decreased by 2.89%, and the von-Mises stress decreased by 2.32%. The side surface tensile stress of concrete under the anchor plate was reduced by 4.3 percent. Finally, three concrete specimens were poured for force transfer testing in the anchorage zone, verifying the safety and reliability of the optimized anchor plate in the 2200 MPa-level prestressed anchorage zone.

Structure Optimization Design of ST/STS Offshore Anchor Based on ANSYS

Analysis on ST OFFSHORE Anchor 3D Modeling & FEA

Free-Fall Penetration Behaviors of A New Dynamically Installed Plate Anchor in Marine Clay

Property Analysis and Structure Optimization of Robotic Arm Based on SolidWorks and ANSYS

A New Bearing Structure of Large Storage Tanks with A Reticulated Shell Dome and its Optimization

Optimized Design of Anchor Plates for 2200 MPa-Class Prestressing Anchorage Zones

A case study on the seabed trenching assessment and anchor design in clay based on the hydrodynamic calculation of the floater

Optimization Analysis On The Structure Parameters Of A 20x10(4)M(3) Ultra-Large Tank For Crude Oil Storage

Analysis and optimization of pre-stressed modal features of ship anchor support parts

A Study on Offshore Anchor Selection with a Focus on Torpedo Anchor Stability and Performance

Bearing Performance of a Novel Caisson-Plate Gravity Anchor

Theoretical solutions for the anchoring force of 3‐D anchored slope and optimization strategy for anchoring force distribution

Structure Optimization of the Pressing Block Tooth in Underwater Skirt Pile Gripper of Offshore Oil Platform

Optimal Design of Engineering Structures and Its Application

The Path-Engulfment Method for Topology Optimization of Structures

Optimization Analysis on the Structure Parameters of a 20×104 m3 Ultra-Large Tank for Crude Oil Storage

Structural Optimization Analysis of 15×10~4 m~3 Ultra-large Oil Storage Tank

Investigation and Improvement of Strut-and-tie Model for Design of End Anchorage Zone in Post-Tensioned Concrete Structure

THE RATIONAL STRUCTURE OF ANCHOR BLOCK BASED ON FINITE ELEMENT ANALYSIS

Whole-ship Structural Optimization under Static and Dynamic Conditions

Stress state analysis and symmetrical optimization of double-row non-symmetrical arrangement of anchorage slot in concrete lining structure