Nanocrystalline diamond modified gold electrode for glucose biosensing.

Wei Zhao,Jing-Juan Xu,Qing-Qing Qiu,Hong-Yuan Chen
DOI: https://doi.org/10.1016/j.bios.2006.01.026
IF: 12.545
2006-01-01
Biosensors and Bioelectronics
Abstract:Boron-doped diamond has drawn much attention in electrochemical sensors. However there are few reports on non-doped diamond because of its weak conductivity. Here, we reported a glucose biosensor based on electrochemical pretreatment of non-doped nanocrystalline diamond (N-NCD) modified gold electrode for the selective detection of glucose. N-NCD was coated on gold electrode and glucose oxidase (GOx) was immobilized onto the surfaces of N-NCD by forming amide linkages between enzyme amine residues and carboxylic acid groups on N-NCD. The anodic pretreatment of N-NCD modified electrode not only promoted the electron transfer rate in the N-NCD thin film, but also resulted in a dramatic improvement in the reduction of the dissolved oxygen. This performance could be used to detect glucose at negative potential through monitoring the current change of oxygen reduction. The biosensor effectively performs a selective electrochemical analysis of glucose in the presence of common interferents, such as ascorbic acid (AA), acetaminophen (AP) and uric acid (UA). A wide linear calibration range from 10μM to 15mM and a low detection limit of 5μM were achieved for the detection of glucose.
What problem does this paper attempt to address?