Abstract:In a pH 5.66 acetate-acetic acid medium, the complex reaction of Al(II) with chlorophosphonazo-mS (MSCPA) is very sensitive. In order to react with Al(III) completely, MSCPA must be added excessively enough. Without doubt, the excess MSCPA in the reaction solution affected the measurement of light-absorption of the Al-MSCPA complex. Thus, ordinary spectrophotmetry is unfit for the measurement of such a complex. To eliminate such an interference, both A(537 nm), and A(618 nm) were selected as the work wavelengths and the spectral correction technique was applied to the characterization of the above complex. The result showed that the composition ratio of Al(III) to MSCPA is 1:1. Using the complexation, a new dual-wavelength approach named the light-absorption ratio variation approach (LARVA) was applied to the determination of trace amounts of Al(III), which often increases the sensitivity up to 10 times better than ordinary spectrophotometry. From the LARVA, the less the MSCPA added, the higher the sensitivity obtained. However, a too low amount of MSCPA caused an obvious error in the measurement because of the noise of instrument background. In the present work, 2.80 micromol x L(-1) MSCPA was added into the Al(III) solution. The absorbance ratio difference (deltaAr) of the Al-MSCPA solution is proportional to the Al(III) concentration in the range of 0 and 0.150 mg x mL(-1). The LOD of Al(III) is only 2 mg x L(-1). The result indicated that many kinds of metal ions did not affect the direct determination of Al(III). Besides, the addition of thiourea solution may mask Fe(III) and Cr(III) effectively. The complexation between Al(III) and MSCPA was completed in 2 min, and the color absorption of solution remained almost constant for more than 1 h. Therefore, a set of continuous flow analysis (CFA) device was designed for the online rapid analysis of Al(III) and coupled with LARVA to increase greatly the analytical efficiency. The results showed that the LOD of Al(III) is 6.5 mg x L(-1) and the analytical rate is about 30 samples per hour. This method has been applied satisfactorily to the determination of trace amounts of aluminum in two chemical reagents, giving recoveries in the range of 97.6%-103.5%.

ADSORPTIVE STRIPPING VOLTAMMETRIC STUDY OF SCANDIUM–ALIZARIN COMPLEXAN COMPLEX AT A CARBON PASTE ELECTRODE

Studies on Adsorptive Voltammetric Determination of Trace Scandium at a Carbon Paste Electrode

Studies On Anodic Adsorptive Stripping Voltammetry Of Gallium (Iii)-Alizarin Complexone At Carbon Paste Electrodes And Its Application

Adsorptive Voltammetric Studies on the Cerium(III)–Alizarin Complexon Complex at a Carbon Paste Electrode

Anodic Adsorptive Stripping Voltammetry at a Carbon Paste Electrode for Determination of Trace Thorium

POLAROGRAPHIC AND VOLTAMMETRIC STUDY OF THE SC(III)-ACID CHROME BLUE-K COMPLEX AND DETERMINATION OF TRACE SCANDIUM

Trace determination of rare earths by adsorption voltammetry at a carbon paste electrode

Mixed Micelle-mediated Extraction and Separation of Scandium from Yttrium and Some Lanthanide Ions

Fast and simple differential pulse adsorptive stripping voltammetric determination of Ce(III) in natural water samples

Catalytic-Adsorptive Stripping Voltammetric Determination Of Chromium In Environmental Materials

Determination of Trace Amounts of Aluminum by Light-Absorption Ratio Variation Combined with Continuous Flow Analysis

Selective solid phase extraction of trace Sc(III) from environmental samples using silica gel modified with 4-(2-morinyldiazenyl)-N-(3-(trimethylsilyl)propyl)benzamide.

Quantitative Determining Of Ultra-Trace Aluminum Ion In Environmental Samples By Liquid Phase Microextraction Assisted Anodic Stripping Voltammetry

Revolutionizing scandium detection in real samples: Unleashing the power of sol–gel-based optical sensor

Highly Selective and Portable Fluorescence Turn-On Detection of Sc3+ in Ore and Water Based on Strong Lewis Acid-Base Coordination

Determination of Trace Chromium by Square-Wave Adsorptive Cathodic Stripping Voltammetry at an Improved Bismuth Film Electrode

Study on the Spectrophotometric Determination of Scandium with Chrome Azurol S in the Presence of Tetradecyl Pyridinium Chloride and Emulgent OP

Quaternization of algal/PEI beads (a new sorbent): Characterization and application to scandium sorption from aqueous solutions

Studies on the stripping voltammetric determination and speciation of chromium at a rotating-disc bismuth film electrode

Determination of aluminum in drinking waters by a.c. oscillopolarography using solochrome violet RS

Separation and preconcentration system based on ultrasonic probe-assisted ionic liquid dispersive liquid-liquid microextraction for determination trace amount of chromium(VI) by electrothermal atomic absorption spectrometry