Abstract:Optical fiber communication systems are going to adopt the use of advanced modulation formats. It is thus important to develop measurement techniques and solutions capable of quantifying such signals. Linear optical sampling is an effective technique to characterize the quality of an advanced modulation format for high-speed optical signal with high fidelity, while the passively mode-locked fiber laser is an enabling module to implement the linear optical sampling. In this paper, we obtain a trade-off relationship between the repetition rate of passively mode-locked fiber laser and the linewidth of high-speed signal under test, after the introduction of operation principle for linear optical sampling. It is found that, for the quadrature phase shift keying (QPSK) signal, when the ratio of the linewidth of the signal under test to the repetition rate of passively mode-locked fiber laser is less than 1.5 × 10?3, the linear optical sampling-induced impairments can be ignored when there occurs phase noise. Therefore, the phase estimation can be successfully made by using the Viterbi-Viterbi algorithm applied to the block of samples corresponding to the modulation format phase states. Next, we use an optical sampling pulse with a repetition rate of 95.984 MHz, and carry out the optical linear sampling to a 28 Gbaud QPSK signal with a linewidth of 100 kHz. The error vector magnitude (EVM) has long been a commonly used parameter for quantifying the quality of advanced modulation signals. Using the standard coherent detection algorithm, we can successfully recover the constellation with the error vector magnitude (EVM) error less than 1%. Theoretical investigations agree well with the experimental characterization. Such a conclusion is helpful to optimize the design of passively mode-locked fiber laser for optical sampling application.

Ultrashort Optical Pulse Monitoring Using Asynchronous Optical Sampling Technique in Highly Nonlinear Fiber

Simultaneous Sampling of Optical Pulse Intensities and Wavelengths by Four-Wave Mixing in A Semiconductor Optical Amplifier

Tunable Compact Asynchronous Optical Sampling System Using Er-doped Fiber Laser

Fast, Long-Scan-range Pump-Probe Measurement Based on Asynchronous Sampling Using a Dual-Wavelength Mode-Locked Fiber Laser.

Optimization of Linear Optical Sampling Analog Front-End and Test for 128 Gb/s Signals

On-field measurement trial of 4×128 Gbps PDM-QPSK signals by linear optical sampling

Fast Linear Optical Sampling with High Repetition-Frequency Using Fiber Delay Lines

Orthogonal Polarization Femtosecond Laser For Optical Sampling

Fiber Optics Frequency Comb Enabled Linear Optical Sampling with Operation Wavelength Range Extension

Tunable Single‐to‐dual Channel Wavelength Conversion of Picosecond Pulses Based on Four‐wave Mixing in Microstructure Fibers

Complete Measurement of Spatiotemporally Complex Multi-Spatial-mode Ultrashort Pulses from Multimode Optical Fibers Using Delay-Scanned Wavelength-Multiplexed Holography.

Repetition Rate Optimization of Passively Mode-Locked Fiber Laser for High-Speed Linear Optical Sampling

Sub-picosecond Resolution Time-Offset Measurement over Fiber Link with Asynchronous Optical Sampling

Widely tunable femtosecond soliton pulse generation in highly nonlinear fiber

Coherent asynchronous sampling distance measurement using a single polarization-multiplexed ultrafast laser

Fast and High-Resolution Spectroscopy Based on Asynchronous Optical Sampling.

Hundred-Femtosecond-Level Concise Optical Time Delay Measurement System Based on Linear Optical Sampling

160 GSa/s All-Optical Pulsed Sampling with a Single Semiconductor Optical Amplifier

Detection And A/D Conversion For 10ghz Periodic Signals With Optical Sampling

Sub-100 femtosecond resolution of clock-offset measurement over a 100 km fiber link with dual-comb sampling

Fast, Asynchronous Sampling Distance Ranging Using an SOA Gate and a Dual-Wavelength Mode-Locked Fiber Laser