Abstract:A droplet impacting a solid surface undergoes deposition, splashing, or rebounding, depending on the properties of the droplet and impacted surface. The deposition pattern attracts lots of attention for the reasons of its predictable behavior on wetting and dewetting. The phenomenon of the central jet, even breaking up into a secondary droplet, is observed during gentle deposition on partially wettable surfaces. The mechanism behind the central jet is addressed by the dual role of the inertia force. In this paper, the dynamic characteristics of droplet deposition are analyzed with a focus on the receding process from jetting to secondary droplet emission. The jet is pinched off into a small secondary droplet when the impacting Weber (We) number is within the range of approximately 26-54. The secondary droplet is then ejected because of the collision with the upward jet. The convergence of capillary waves on the liquid film is employed to explain the two-stage upward jet. The jet tip is pinched off because of Rayleigh-Plateau instability, leading to the generation of the secondary droplet. A geometric model of a two-floor cylinder is further proposed to describe the equivalent recession of the capillary wave. The equivalent radius of the receding wave is linear with time, and the jet height exhibits a scaling law of Djet ∼ (t - 0.8)1/2 with normalized time. Additionally, the dynamic characteristics are investigated from time and size views. With various Weber numbers, the normalized receding, jetting, and tip times are found to remain almost constant. A piecewise relationship with the Weber number is revealed for the normalized receding wave and the tip height. The wave recedes at the characteristic velocity of 0.23 m/s. Moreover, the normalized jet height and tip diameter, as well as secondary droplet diameter, are independent of the inertia force. The emission velocity and kinetic energy of the secondary droplet are found to reach the maximum at We ∼ 41.6.

Prediction of the Size Distribution of Secondary Ejected Droplets by Crown Splashing of Droplets Impinging on a Solid Wall

Backward Formalism to Derive the Size of Secondary Ejected Droplets Produced by Crown Splashing of Drops Impinging on a Solid Wall

Characteristics of Secondary Droplets Produced by the Impact of Drops Onto a Smooth Surface

Predicting the Splash of a Droplet Impinging on Solid Substrates.

Experimental Correlation for Splashing Condition of Droplets on Solid Substrates

Analytical Consideration of Liquid Droplet Impingement on Solid Surfaces

A New Criterion for the Splashing of a Droplet on Dry Surface from High-Fidelity Simulations

Receding Dynamics of Droplet Deposition on a Smooth Surface from a Central Jet to Secondary Droplet Emission

Droplet Splashing on Rough Surfaces

Effects of Surface Roughness on Splashing Characteristics of Large Droplets with Digital Inline Holographic Imaging

A Fitting Formula for Predicting Droplet Mean Diameter for Various Liquid in Effervescent Atomization Spray

Impact of droplet on flowing liquid film: Experimental and numerical determinations

Visual experimental study of droplet impinging on liquid film and analysis of droplet evolution characteristics

Numerical study on dynamics of oblique hollow droplet impact on a liquid film

Predicting the Splash of a Drop Impacting a Thin Liquid Film

Numerical Simulation of Single Droplet Impingement Upon Dynamic Liquid Film Obliquely

Prediction of the droplet size distribution in aerodynamic droplet breakup

Growth and instability of the liquid rim in the crown splash regime

Droplet Impact on Wetted Structured Surfaces

Splash of Impacting Nanodroplets on Solid Surfaces

Effect of wettability on droplet impact: Spreading and splashing