Abstract:OBJECTIVES:Vocal fold tissue is biphasic and consists of a solid extracellular matrix skeleton swelled with interstitial fluid. Interactions between the liquid and solid impact the material properties and stress response of the tissue. The objective of this study was to model the movement of liquid during vocal fold vibration and to estimate the volume of liquid accumulation and stress experienced by the tissue near the anterior-posterior midline, where benign lesions are observed to form.METHODS:A three-dimensional biphasic finite element model of a single vocal fold was built to solve for the liquid velocity, pore pressure, and von Mises stress during and just after vibration using the commercial finite element software COMSOL Multiphysics (Version 4.3a, 2013, Structural Mechanics and Subsurface Flow Modules). Vibration was induced by applying direct load pressures to the subglottal and intraglottal surfaces. Pressure ranges, frequency, and material parameters were chosen based on those reported in the literature. Postprocessing included liquid velocity, pore pressure, and von Mises stress calculations as well as the frequency-stress and amplitude-stress relationships.RESULTS:Resulting time-averaged velocity vectors during vibration indicated liquid movement toward the midline of the fold, as well as upward movement in the inferior-superior direction. Pore pressure and von Misses stresses were higher in this region just after vibration. A linear relationship was found between the amplitude and pore pressure, whereas a nonlinear relationship was found between the frequency and pore pressure.CONCLUSIONS:Although this study had certain computational simplifications, it is the first biphasic finite element model to use a realistic geometry and demonstrate the ability to characterize liquid movement due to vibration. Results indicate that there is a significant amount of liquid that accumulates at the midline; however, the role of this accumulation still requires investigation. Further investigation of these mechanical factors may lend insight into the mechanism of benign lesion formation.

Modeling Vocal-fold Vibration Via Integrating Two-mass Model with Finite-Element Method

Modeling Vocal Fold Motion with a Continuum Fluid Dynamic Model, I. Derivation and Analysis

A New Biomechanical Model Of Vocal Fold Vibrations: Preliminary Experimental Validation

Simulation of Phonation Control Using a Tensile Vocal-Fold Model

Laryngeal Muscular Control of Vocal Fold Posturing: Numerical Modeling and Experimental Validation.

Modeling Vocal Fold Motion with a New Hydrodynamic Semi-Continuum Model

A one-dimensional flow model enhanced by machine learning for simulation of vocal fold vibration

Studying the Vocal Fold Vibration Using A Nonlinear Finite-Element Model

A self-oscillating biophysical computer model of the elongated vocal fold

Characterizing Liquid Redistribution in a Biphasic Vibrating Vocal Fold Using Finite Element Analysis

Fully-coupled aeroelastic simulation with fluid compressibility - For application to vocal fold vibration

A fluid-saturated poroelastic model of the vocal folds with hydrated tissue.

Synthetic, self-oscillating vocal fold models for voice production researcha)

Asymmetric Airflow and Vibration Induced by the Coanda Effect in a Symmetric Model of the Vocal Folds.

Extracting Physiologically Relevant Parameters of Vocal Folds from High-Speed Video Image Series

Numerical Investigation of the Influence of Thyroarytenoid and Cricothyroid Muscle Contraction on the Geometry and Biomechanical Properties of the Vocal Folds

Liquid Dynamics in a Self-Oscillating Poroelastic Model of the Vocal Fold

Mechanical Stress During Phonation In A Self-Oscillating Finite-Element Vocal Fold Model

Simulation of Vocal Fold Impact Pressures with a Self-Oscillating Finite-Element Model.

The anisotropic hyperelastic biomechanical response of the vocal ligament and implications for frequency regulation: a case study

Nonlinear Oscillation of Pathological Vocal Folds During Vocalization