Abstract:OBJECTIVES:Vocal fold tissue is biphasic and consists of a solid extracellular matrix skeleton swelled with interstitial fluid. Interactions between the liquid and solid impact the material properties and stress response of the tissue. The objective of this study was to model the movement of liquid during vocal fold vibration and to estimate the volume of liquid accumulation and stress experienced by the tissue near the anterior-posterior midline, where benign lesions are observed to form.METHODS:A three-dimensional biphasic finite element model of a single vocal fold was built to solve for the liquid velocity, pore pressure, and von Mises stress during and just after vibration using the commercial finite element software COMSOL Multiphysics (Version 4.3a, 2013, Structural Mechanics and Subsurface Flow Modules). Vibration was induced by applying direct load pressures to the subglottal and intraglottal surfaces. Pressure ranges, frequency, and material parameters were chosen based on those reported in the literature. Postprocessing included liquid velocity, pore pressure, and von Mises stress calculations as well as the frequency-stress and amplitude-stress relationships.RESULTS:Resulting time-averaged velocity vectors during vibration indicated liquid movement toward the midline of the fold, as well as upward movement in the inferior-superior direction. Pore pressure and von Misses stresses were higher in this region just after vibration. A linear relationship was found between the amplitude and pore pressure, whereas a nonlinear relationship was found between the frequency and pore pressure.CONCLUSIONS:Although this study had certain computational simplifications, it is the first biphasic finite element model to use a realistic geometry and demonstrate the ability to characterize liquid movement due to vibration. Results indicate that there is a significant amount of liquid that accumulates at the midline; however, the role of this accumulation still requires investigation. Further investigation of these mechanical factors may lend insight into the mechanism of benign lesion formation.

Mechanical Stress During Phonation In A Self-Oscillating Finite-Element Vocal Fold Model

Simulation of Vocal Fold Impact Pressures with a Self-Oscillating Finite-Element Model.

Simulation of Phonation Control Using a Tensile Vocal-Fold Model

Numerical Investigation of the Influence of Thyroarytenoid and Cricothyroid Muscle Contraction on the Geometry and Biomechanical Properties of the Vocal Folds

Studying the Vocal Fold Vibration Using A Nonlinear Finite-Element Model

A fluid-saturated poroelastic model of the vocal folds with hydrated tissue.

A self-oscillating biophysical computer model of the elongated vocal fold

Experimental Study and Theoretical Simulation of Stress Relaxation Behavior of Vocal Fold Lamina Propria Tissue.

A Biphasic Theory for the Viscoelastic Behaviors of Vocal Fold Lamina Propria in Stress Relaxation.

Liquid Dynamics in a Self-Oscillating Poroelastic Model of the Vocal Fold

Modeling the Pathophysiology of Phonotraumatic Vocal Hyperfunction With a Triangular Glottal Model of the Vocal Folds

The anisotropic hyperelastic biomechanical response of the vocal ligament and implications for frequency regulation: a case study

Asymmetric Airflow and Vibration Induced by the Coanda Effect in a Symmetric Model of the Vocal Folds.

Measurement of Stress in Vocal Folds During Phonation Using Spatiotemporal Synchronization

The Influence of Thyroarytenoid and Cricothyroid Muscle Activation on Vocal Fold Stiffness and Eigenfrequencies

Characterizing Liquid Redistribution in a Biphasic Vibrating Vocal Fold Using Finite Element Analysis

Acoustic, aerodynamic, and vibrational effects of ventricular folds adduction in an ex vivo experiment

Effects of Mucosal Loading on Vocal Fold Vibration.

Synthetic, self-oscillating vocal fold models for voice production researcha)

Laryngeal Muscular Control of Vocal Fold Posturing: Numerical Modeling and Experimental Validation.

Modeling Vocal Fold Motion with a Continuum Fluid Dynamic Model, I. Derivation and Analysis