Abstract:Conventionally, micro-sized irregular polyaniline (PANI) particles were synthesized by dropwise addition of the ammonium persulfate (APS) solution into the aniline (ANI) solution with mechanical stirring. By replacing the mechanical stirring with an ultrasonic irradiation, PANI nanofibers in diameters of ∼50nm and lengths of 200nm to several micrometers were prepared. Transmission electron microscopy (TEM) and scanning electron microscopy (SEM) showed that at the early stage of polymerization, the polymers formed in both the mechanical stirred and ultrasonicated systems are in the form of nanofiber. However, with continuing of the reaction, these primary nanofibers grow and agglomerate into irregular shaped PANI particles in the mechanical stirred system, while in the case of the ultrasonic irradiation, the growth and agglomeration are effectively prevented, preserving thus the PANI nanofibers in the final product. By increasing the APS/ANI molar ratio from 0.5 to 2.5, the aspect ratios of the PANI nanofibers decreased. The PANI nanofibers exhibit higher solubility than the irregular shaped PANI particles. Although the yield, as well as the conductivity of the ultrasonic synthesized PANI nanofibers, was slightly lower than the irregular shaped PANI particles, the ultrasonic synthesis approach is one of the facile and scalable approaches in synthesizing PANI nanofibers in comparison with other ones without use of templates (e.g., the interfacial polymerization and rapid mixing polymerization). UV–Vis and Fourier transformed infrared (FTIR) spectra indicated ultrasound had no significant effect on the chemical structure of the PANI.

Templated Synthesis of Cds/Pan Composite Nanowires under Ambient Conditions

Preparation of ZnO/PANi Composite Nanowire and Their Interactions on Interface between ZnO and PANi

Solvothermal Synthesis and Characterization of Uniform CdS Nanowires in High Yield

Solvothermal Synthesis and Characterization of CdS Nanowires/pva Composite Films

Synthesis of CdS nanotubes by chemical bath deposition

Synthesis and Characterization of Polymer-Cds Nanocomposites

Synthesis Of Short Cds Nanofiber/Poly(Styrene-Alt-Maleic Anhydride) Composites Using Gamma-Irradiation

Synthesis of Single Crystalline CdS Nanorods by a PVP-assisted Solvothermal Method

Solvothermal Synthesis of CdS Nanowires in a Mixed Solvent of Ethylenediamine and Dodecanethiol

Synthesis of Large-Area Three-Dimensional Polyaniline Nanowire Networks Using a ?Soft Template?

Preparation of dendritic and network PANI/silica composite fibers

Fabrication of CdS/polyacrylonitrile nanocomposites by γ-irradiation in an ethanol solution

Integration of CdS with a Fiber-Based Cadmium Coordination Polymer for Turning On Photocatalytic Oxidative Coupling Reactions

Preparation of Nanosize CdS／PANI Film and Its Photoelectric Properties

Controllable Synthesis of Straight and Branched Cdte Nanowires Using Cdo As Precursor

Sonochemical Synthesis of Polyaniline Nanofibers

Trioctylphosphine As Both Solvent and Stabilizer to Synthesize CdS Nanorods

Synthesis, Characterization and Optical Properties of CdS Nanorods by a Simple Solution Chemistry Method

High-Yield Two-Dimensional CdS Nanowire Networks Synthesized by a Low-Temperature Chemical Method

Synthesis of closed PbS nanowires with regular geometric morphologiesElectronic supplementary information (ESI) available: XRD pattern of the PbS CNWs, FTIR spectrum of the polymer, TEM images of more PbS CNWs. See http://www.rsc.org/suppdata/jm/b1/b111187f/

Porous CdS Nanowire Arrays Self-assembled in Anodic Aluminum Oxide Template