Abstract:At low overvoltage values, deviations from Tafel behavior for a noncorroding electrode are due primarily to the reverse reaction of the oxidation‐reduction system, and at high overvoltages to concentration and/or resistance polarization. It is shown further that the practice of placing straight lines through a few experimental points is extremely hazardous, while the indiscriminate introduction of "breaks" is contrary to the electrode kinetics described.Further complexities arising from a corroding electrode are described. In this instance, the forward and reverse reactions of both of the oxidation‐reduction systems forming the corrosion couple must be considered. This representation of the local polarization diagram of a corroding metal is more fundamental than that used previously in the literature, and thus provides a clearer picture of the various factors which affect the corrosion rate and the shape of polarization curves.A region of linear dependence of potential on applied current is described for a corroding electrode by treating it in a manner analogous to that for a noncorroding electrode. An equation is derived relating the slope of this linear region to the corrosion rate and Tafel slopes. This relation provides an important new experimental approach to the study of the electrochemistry of corroding metals since, in some instances, interfering reactions prevent determination of Tafel slopes at higher current densities.

Determination of Polarization Curve of Zinc and Application Experiment

The Effect of Suspended Particles on the Corrosion Resistance of Electrodeposited Zinc Powders

Analysis of Polarization Curves Characteristics of Rebar in Concrete

THEORY OF THE POLARIZATION CURVE TECHNIQUE FOR STUDYING CORROSION AND ELECTROCHEMICAL PROTECTION

II. Fundamental Electrochemical Methods for Corrosion－Polarization Curve（i-V Curve）－

Polarization curve measurement of corrosion rate of hot-dipped component in transmission equipment and parameter optimization

Experiment Reform of Determination of Polarization Curve in Physical Chemistry Experiment

Corrosion of Zinc in Simulated Acid Rain Solution and under Thin Electrolyte Layer Formed by Simulated Acid Rain Solution

Probing the Corrosion Mechanism of Zinc under Direct Current Electric Field

EIS analysis on the anodic process of zinc in an alkaline solution

Electrochemical Tests on Zincating Solution with Zinc Sulfate and Zinc Oxide

Polarization Characteristic of Iron Anode in Concentrated NaOH Solution

PRODUCTION OF POLAR ZINC ELECTRODE BY COMPOSITION METHOD AND THE ANALYSIS OF ITS PHYSICOCHEMISTRY PROPERTY

The Effect of External DC Electric Field on the Atmospheric Corrosion Behaviour of Zinc under a Thin Electrolyte Layer

The Influences of Polyoxyethylene Ether on the Corroision Behaviors of Zinc and Zn-In Alloy in Alkaline Solutions

Electrochemical Polarization I . A Theoretical Analysis of the Shape of Polarization Curves

Electrodeposition of Zinc from Galvanized Steel

The Cathodic Polarization of Electrodepositing Zn-Ni Alloy Coatings

Influence of Applied Voltage on Steel Corrosion Investigated Through Linear Polarization Method

Corrosion Behavior of Pure Zinc and Its Alloy under Thin Electrolyte Layer

The Applicability of Eis to Determine the Optimal Polarization Potential for Impressed Current Cathodic Protection