Abstract:Partial discharges (PD) measurements provide valuable information for the condition assessment of the high voltage insulation systems. PD tests have become a fundamental tool to determine the status of high voltage elements, contributing to the quality assurance in high voltage equipment. Some reasons for the increasing usage of DP tests are based in the effectiveness of the new developments presented to achieve more reliable diagnosis. During the last five decades different approaches have been developed and applied to PD measurement and processing techniques. Significant efforts have been made to deal with the most common problems arising in on-site and on-line measurements: high levels of noise and interferences, the emergence of different PD sources simultaneously and the difficulty of locating the site of the defects and to identify the type of defects. In order to overcome all these drawbacks, this paper proposes an efficient method based in advanced measuring and diagnosis techniques, with the aim to achieve a proper sensitivity in PD measurements and an accurate assessment of the elements insulation condition. In PD measurements the main factors that condition the signal acquisition, the subsequent processing and the capability to obtain an accurate diagnosis are: selection of a suitable detection technique together with the type of sensors and their bandwidth, implementation of an effective noise filtering tool, development of a defect localization method and implementation of PD classification techniques for pattern recognition and defect identification. All these factors have been considered in this study and a complete measuring method together with powerful diagnostic tools are presented. Measurements in a test object consisting in a one-phase cable system were accomplished with real insulation defects, with the aim to show the effectiveness of the proposed method and the optimized analysis techniques.

An Improved Optically Based Pd Detection System for Continuous On-Line Monitoring of Hv Cables

Optically Based Partial Discharge Continuous Monitoring System For Hv Cable Joints

Application of Superluminescent Light Emitting Diode to Electrooptic Modulator Based PD Continuous On-line Monitoring System

Miniature Optical Signal Transmission System for PDN Noise Measurement

Development of Distributed On-line PD Monitoring System for Cables

Signal Processing of On-line Partial Discharge Measurements On HV Power Cables

DSP Based On-Line Partial Discharge Monitoring System for High Voltage Power Cable

Comparison of Pd Detection Methods for Power Transformers - Their Sensitivity and Characteristics in Time and Frequency Domain

Study of Noise-reject Technique for PD Online Monitoring on Cable Joint

On-line Calibration of Partial Discharge Monitoring for Power Cable by HFCT Method

Application Of The Online Partial Discharge Monitoring For The Ehv Xlpe Cable System

Study Of On-Line Monitoring Method Of Partial Discharge For Power Transformers Based On Rfct And Microstrip Antenna

Partial Discharge Ultrasonic Detection Based on Sagnac Optical Interference Technique

Low-Cost Online Partial Discharge Monitoring System for Power Transformers

On-line partial discharge monitoring system and data processing using WTST-NST filter for high voltage power cable

Partial Discharge Detection and Sensitivity Improvement for Bushing Based on Optical Interference Technique

Study of Anti-interference Technology for UHF PD-Detection in Power Transformers

RESEARCH AND DEVELOPMENT OF ON-LINE MONITORING SYSTEM WITH PARTIAL DISCHARGE IN XLPE POWER CABLES

Advanced techniques for on-line PD measurements in high voltage systems

Comparison of on-line partial discharge detection methods for HV cable joints

On-line and on-site PD monitoring and diagnosis of power transformer