Abstract:Pool boiling is a widely encountered heat transfer phenomenon and the enhancement of boiling heat transfer performance is of vital importance for real applications. Adding surfactant into distilled water is regarded to be a promising and effective approach for heat transfer improvement. The present study selected four kinds of quaternary ammonium cationic surfactants with an increased molecular weight, namely, decyltrimethylammonium bromide (DeTAB), dodecyltrimethylammonium bromide (DoTAB), myristylmethylammonium bromide (MTAB) and cetyltrimethylammonium bromide (CTAB), to investigate the pool boiling performance of their aqueous solutions on a copper heater with and without electric field under different concentrations. Their dynamic surface tensions and viscosities were also measured. The bubble dynamics during pool boiling and apparent contact angle on copper surface before and after boiling test were evaluated. Experimental results reveal that the aqueous surfactant solution can significantly enhance the heat transfer coefficient (HTC) compared with distilled water. The HTC exhibits an increment with concentration until critical micelle concentration (CMC) and then levels off. The maximum relative HTC enhancement can reach up to 209.3%, which is ascribed to the increased nucleate site and bubble departure frequency. In addition to the reduction in surface tension, a repulsion force caused by electrostatic interaction is also responsible for the changes in nucleate site and bubble departure frequency. However, the critical heat flux (CHF) shows a continuous decrement with surfactant concentration. In a low concentration surfactant solution, the CHF is even slightly higher than that of water, which is caused by an improvement in surface wettability after boiling test. The CHF in moderate and high surfactant concentration will be lower. The surfactant with a smaller CMC tends to have a higher HTC and a lower CHF under a low concentration. However, for a relatively high concentration comparative to CMC, the four kinds of quaternary ammonium cationic surfactant solutions tend to have pretty similar boiling curves. The electric field is found to have a negligible influence on the pool boiling performance in aqueous surfactant solutions. Results in present study can provide valuable guidance for surfactant selection during the design of highly effective heat exchangers.

POOL BOILING HEAT TRANSFER ENHANCEMENT IN BINARY MIXTURES BY SURFACTANT ADDITIVES

Effects of Surfactants on Subcooled Pool Boiling Characteristics: an Experimental Study

Effects of surface wettability on nucleate pool boiling heat transfer for surfactant solutions

Experimental Study on Pool Boiling Heat Transfer of Perfluoroalkyl Surfactant Solutions

Subcooled Pool Film Boiling Heat Transfer from Spheres with Superhydrophobic Surfaces: an Experimental Study

Effects of Surfactant on Flow Boiling Heat Transfer of Ethylene Glycol/Water Mixtures in a Minitube

Effects of surfactant additive on flow boiling over a microheater under pulse heating

Bubble behaviors during subcooled pool boiling in water and nonionic surfactant aqueous solution

Pool boiling heat transfer enhancement of aqueous solution with quaternary ammonium cationic surfactants on copper surface

Boiling Heat Transfer Enhancement of Nanofluids on a Smooth Surface with Agitation

Vapor bubble–bubble penetration during subcooled pool boiling in a nonionic surfactant aqueous solution

Investigation of Heat Transfer Performance in Deionized Water–Ethylene Glycol Binary Mixtures during Nucleate Pool Boiling

An experimental investigation of enhanced pool boiling heat transfer from surfaces with micro/nano-structures

Regulated Transient Pool Boiling of Water During Quenching on Nanostructured Surfaces with Modified Wettability from Superhydrophilic to Superhydrophobic

Effect of nanoparticle concentration and surfactants on nanofluid pool boiling

A Study on Enhancement of Boiling Heat Transfer by Mixed-Wettability Surface

Comparison of pool boiling heat transfer performance between aqueous cationic and anionic surfactant solutions with similar ionic group

Molecular Dynamics Simulation of Interfacial Heat Transfer Characteristics of CO2, R32 and CO2/R32 Binary Zeotropic Mixture on a Smooth Substrate

Enhancing heat transfer ability of drag reducing surfactant solution

Experimental study on subcooled pool boiling heat transfer of sodium dodecyl sulfate surfactant solution

Pool boiling heat transfer performance and mechanism of square copper pillar arrays with partially-modified surface