Abstract:Layer structured oxides with transition metals such as Ni, Co, and Mn have been considered as good cathode materials to replace LiCoO2 for lithium batteries due to their lower cost and higher capacity. The thermal instability in charged, especially over charged states at elevated temperatures, however, is still a major concern on this class of materials. Recently, we have developed a technique using the combination of a high intensity synchrotron x-ray beam and a fast image plate detector to do time resolved x-ray diffraction during the thermal decomposition of charged cathode materials in the presence of electrolyte. In order to understand the controlling mechanism of thermal runaway of the electrodes in Li-ion cells, we have monitored structural changes of the charged nickel-based cathode materials in the presence of electrolyte. We have also developed synchrotron based in situ and ex situ soft x-ray absorption spectroscopy (XAS) techniques which allows us to distinguish the structural differences between surface and bulk of electrodes using both electron yield (EY) and fluorescence yield (FY) detectors simultaneously. In this presentation, we will report our studies on the structural changes of cathode materials during heating with and without the presence of the electrolytes, as well as the structural differences between the surface and the bulk during heating. Our recent studies on Co, Al, Mn doped LiNiO2-based materials using time-resolved X-ray diffraction (XRD) and X-ray absorption spectroscopy (XAS) with or without the presence of electrolyte show a series of phase transformations during heating [1]. However, due to the averaging nature of X-ray techniques, detailed information about how the structure changes initiated and propagated through new phase nucleation and growth in the microscopic level is quite limited. Therefore further studies using a local probe with high spatial resolution are needed. Here, we present our insitu transmission electron microscopy (TEM) studies on the structural changes of over charged Li0.0Ni0.8Co0.15Al0.05O2 and Li0.0Ni1/3Co1/3Mn1/3O cathode materials during heating, in comparison with our XRD and XAS studies. High resolution transmission electron microscopy (HRTEM) and electron diffraction were carried out using JEM-3000F equipped with an ultra high resolution (UHR) objective-lens pole-piece, an offaxis 1024 x 1024 Gatan slow-scan camera, a post column Gatan imaging filter (GIF), a NORAN X-ray detector, and a Gatan double-tilt heating stage capable with temperature ranging from room temperature to 1000 oC. The Li0.0Ni0.8Co0.15Al0.05O2 particles harvested from overcharged cell were first examined at room temperature. Electron diffraction and HRTEM show that the main phase is a layered structure with rhombohedral symmetry. Interestingly, rock-salt structure and spinel structure, which only observed at elevated temperatures using X-ray techniques, were presented at the edges and thin areas of the particles, respectively even at room temperature. This implies that after overcharging, the particles start losing some oxygen atoms near the particle surface, resulting in the structural changes. By heating the sample, we observed that the phase with the spinel structure nucleates and grows more and more into the thick area of the particles, while the rock-salt phase propagates from the surface to the interior of the particles. After heating the sample to 400 oC, the structure of the whole sample completely transformed to the rock-salt structure. For the over-charged Li0.0Ni1/3Co1/3Mn1/3O2 sample, spinel structure was also observed on the surfaces of the particles at room temperature. The olivine-structured LiFePO4 and LiFeMPO4 (M=Mn, Co, Ni) solid solution type cathode materials have been studied intensively recently [2-8], due to their high thermal and electrochemical stabilities and good safety characteristics. The in depth understanding of the structural changes during charge-discharge cycles will provide guidance for developing new materials. Using synchrotron based in situ XRD, hard and soft x-ray XAS, and TEM, the structural changes of these materials have been studied during chargedischarge cycling. The differences of phase transition processes between the surface and the bulk will be discussed.

A Comparative Study of Overdischarge Behaviors of Cathode Materials for Lithium-Ion Batteries

A Comparative Study of Degradation Behaviors of LiFePO 4 , LiMn 2 O 4 , and LiNi 0.8 Mn 0.1 Co 0.1 O 2 in Different Aqueous Electrolytes

Insight into the cation migration and surface structural evolution of spinel LiNi0.5Mn1.5O4 cathode material for lithium-ion batteries

Investigation on the Overlithiation Mechanism of LiCoO 2 Cathode for Lithium Ion Batteries

Revealing the voltage decay of LiMn0.7Fe0.3PO4 cathodes over cycling

Electrochemical and ex situ XRD studies of a LiMn1.5Ni0.5O4 high-voltage cathode material

Synthetic Optimization and Electrochemical Properties of LiNi_(0.5)Mn_(0.5)O_2 Cathode Materials for Lithium-ion Batteries

Probing Reversible Multielectron Transfer and Structure Evolution of Li1.2Cr0.4Mn0.4O2 Cathode Material for Li-Ion Batteries in a Voltage Range of 1.0–4.8 V

The Decay Mechanism Related to Structural and Morphological Evolution in Lithium‐Rich Cathode Materials for Lithium‐Ion Batteries

Comparative Studies Between Surface and Bulk Structural Changes During Heating and Cycling for Layer-Structured and Olivine-Structured Cathode Materials

Recent Progress of High Voltage Spinel LiMn1.5Ni0.5O4 Cathode Material for Lithium-Ion Battery: Surface Modification, Doping, Electrolyte, and Oxygen Deficiency

Unconventional irreversible structural changes in a high-voltage Li–Mn-rich oxide for lithium-ion battery cathodes

Fatigue in 0.5li2mno3:0.5Li(ni1/3co1/3mn1/3)o2 Positive Electrodes for Lithium Ion Batteries

Voltage Decay in Layered Li-Rich Mn-Based Cathode Materials

Study of the Lithium/nickel Ions Exchange in the Layered LiNi0.42Mn0.42Co0.16O2 Cathode Material for Lithium Ion Batteries: Experimental and First-Principles Calculations

Overlithiation-driven structural regulation of lithium nickel manganese oxide for high-performance battery cathode

Electrochemical Behaviours and Structure Evolution of High Capacity Li1.2Cr0.4Mn0.4O2 Cathode Material in a Wide Voltage Range

Recent Progress of High Voltage Spinel LiMn 1.5 Ni 0.5 O 4 Cathode Material for Lithium-Ion Battery: Surface Modification, Doping, Electrolyte, and Oxygen Deficiency

Specific Countermeasures to Intrinsic Capacity Decline Issues and Future Direction of LiMn 2 O 4 Cathode

A New Insight into Continuous Performance Decay Mechanism of Ni-rich Layered Oxide Cathode for High Energy Lithium Ion Batteries

Impact of Ni Content on the Electrochemical Performance of the Co-Free, Li and Mn-Rich (Lmr) Layered Cathode Materials