Abstract:The research and development of compact repetitive miniature plasma focus devices, with stored energy from few tens to few hundred joules, is becoming increasingly important because of their potential applications as portable neutron source for explosive and contraband material detection. In this paper, we report the neutron emission results from our most updated version of Fast Miniature Plasma Focus device, namely FMPF-3. The FMPF-3 (2.4 µF, 34 nH, 103 kA @ 14.0 kV, T/4 ∼460 ns) is an advanced prototype of previous versions of FMPF series which achieves higher performance through the use of four parallel pseudo-spark gap switches for each module instead of single switch used in FMPF-2. This lead to the lower system impedance and hence higher discharge current with further enhancement in neutron to record time average yield of (1.2±0.2)×107 neutrons/sec at 10Hz operation. The analysis of experimental data for plasma focus devices with stored bank energies of 400 J to 1 MJ showed the neutron yield scaling with peak discharge current as Yn∼I3.9. The scaling law at the lower energy limits of 120 – 235 J for FMPF-3 was found to scale on higher side as Yn∼I6.9. The shot to shot stability of neutron emission was tested at different repetition rates from 1 to 10 Hz for shot sequence of 50 shots. It was realized that if the device is operated at the pressure optimized for single shot operation then the neutron yield decreases monotonously after about 30 shots. The increase in operating deuterium pressure lead to the stabilization of neutron yield for 50 shot sequence for repetitive operations. In addition to above results, the paper will also discuss briefly the conceptualization and development of FMPF-3, along with key technical and physical issues and challenges encountered.

Design of flextensional transducer based on finite element method

The Design And Finite Element Analyses Of The Super-Long Ultrasonic Amplitude Transformer

Numerical and experimental investigation of a variable-curvature shell class I flextensional transducer

Finite Element Analysis and Theoretical Model of Slotted Cymbal Composite Piezoelectric Transducer

High performance repetitive low energy miniature plasma focus neutron source: Record yield, scaling laws and yield stability

Finite Element Calculation with Experimental Verification for a Free-Flooded Transducer Based on Fluid Cavity Structure

Terfenol-D giant magnetostrictive transducer simulation byfinite element method

Finite Element Method Based on High Order Mesh for Traveling-wave Tube Simulation

Structural Optimization and Performance of a Low-Frequency Double-Shell Type-IV Flexural Hydroacoustic Transducer

Structural Design and Optimization of Low-Frequency High-Power Electromagnetic Transducer

Research and Fabrication of High-Frequency Broadband and Omnidirectional Transmitting Transducer

Acupuncture-Induced Blood Oxygenation Level-Dependent Signals in Awake and Anesthetized Volunteers: A Pilot Study

Simulation and Optimization of Wedge-Shaped Ultrasonic Transducers Using Finite Element Method (Fem)

Design simulation and analysis of deep-sea transducer

Modeling of Lorentz forces and radiated wave fields for bulk wave electromagnetic acoustic transducers

A Finite Element Method for Dielectric Elastomer Transducers

A Low-Frequency Unidirectional Underwater Acoustic Transducer

Simulation of an Electromagnetic Acoustic Transducer Array by Using Analytical Method and FDTD

Design and Simulation of Flexible Underwater Acoustic Sensor Based on 3D Buckling Structure

A distributed parameter model of the Janus–Helmholtz transducer

Design of Ultrasonic Transducer with a Quarter Wavelength Composite Exponential Horn