Abstract:This study addresses the issue of unsatisfactory smoothness in the movement of integrated internal and external cross roller bearings post-assembly, which compromises the movement flexibility of the finished bearing and fails to meet index requirements. Focusing on a specific type of precision cross roller bearing, this paper establishes a finite element explicit dynamic simulation model that takes into account the plugging position and matching relationship. A transient dynamic simulation of the roller blockage process was conducted, yielding insights into the contact pressure and deformation experienced by the roller and plug during this blockage. The results indicate that when both the taper pin are positioned centrally, and the plug matching clearance, plug sag and protruding amount, and plug rotation offset degrees are all set to 0 μm, the contact pressure between the roller and raceway, as well as the roller deformation displacement, are minimized. The plugging position and fit were subsequently validated through testing, which also measured the impact of these parameters on the roundness of the raceway surface and the bearing's friction torque. The test findings corroborate that when the taper and pin are centrally aligned, and the stopper clearance is 5 μm, with the plug sag, protrusion, and offset all at 0 μm, the roundness of the raceway surface and the bearing's friction torque reach their lowest values, thereby optimizing the stability of bearing motion. By comparing the simulation and experimental results, it is concluded that during bearing assembly, it is crucial to maintain the taper pin in a central position, control the plug matching clearance to approximately 5 μm, and ensure the plug sag, protrusion, and rotation offset amount are both at 0 μm. This approach guarantees optimal contact conditions and motion stability during operation. The findings of this research offer valuable design guidance for the selection of appropriate plugging positions and fits in precision cross roller bearings.

Effects of Misalignment in Tapered Roller Bearings on Contact Between Roller and Inner Ring

The Influence of Coupling Misalignment on Dynamic Characteristics of Helical Gear System

Effect of angular misalignment of inner ring on the contact characteristics and stiffness coefficients of duplex angular contact ball bearings

Effect of the ring misalignment on the service characteristics of ball bearing and rotor system

Contact of Tapered Roller with Logarithmic Profile

Effects of three types of bearing misalignments on dynamic characteristics of planetary gear set-rotor system

Transient characteristics of misaligned roller bearing considering thermal-fluid-solid coupled

Investigation on the lubrication characteristics of low-viscosity lubricated micro-grooved bearings considering turbulence and misalignment

Effects of supporting stiffness of deep groove ball bearings with raceway misalignment on vibration behaviors of a gear-rotor system

Vibration characteristics of bearing-rotor systems with inner ring dynamic misalignment

Study on Grinding-Affected Layer of Outer-Ring Inner Raceway of Tapered Roller Bearing

Effect of static and dynamic misalignment of rolling bearing on nonlinear vibration characteristics of rotor system

Analysis on Contact of Needle Roller Bearings

Theoretical and experimental investigation on the influences of misalignment on the lubrication performances and lubrication regimes transition of water lubricated bearing

Experimental investigation on the effect of misalignment on the wear failure for spline couplings

Effects of misalignment on surface wear of spur gears

An Investigation for the Friction Torque of a Tapered Roller Bearing Considering the Geometric Homogeneity of Rollers

Study on the Influence of Plugging Position and Fit on the Motion Stability of Precision Cross Roller Bearing

Manufacturing error and misalignment effect on the transient lubrication behavior of dynamically loaded journal bearing with micro-groove

Study on the Influence of Thermal Characteristics of Rolling Bearings and Spindle Resulted in Condition of Improper Assembly

Bi-directional misalignment effects on transient tribo-dynamics of offset-halves journal bearings subjected to step loading