Abstract:The heat pipe cooled reactor is an advanced reactor design which is nearly solid-state with an array of in-core heat pipes for passive heat transfer. The local heat pipe failure probability is certainly high over the reactor lifetime. Therefore, the reactor design must include consideration of heat pipe failure accidents which needs to be explored in-depth. The Monte Carlo neutron transport code RMC was used with the general finite element analysis software ANSYS Mechanical to analyze the thermal/mechanical characteristics of a megawatt heat pipe cooled reactor for both normal and heat pipe failure conditions. The simulations were verified against a previous study with the predicted temperature distributions being consistent with each other with an absolute error of less than 3 K. Further analyses show that a 2-D model simulation can also well represent the 3-D model for heat pipe failure accident analyses. Sterbentz et al. (2017) simplified the heat pipe model with a constant temperature boundary condition along the evaporator wall of 950.15 K regardless of the heat load or heat pipe operating temperature. Therefore, a heat pipe subroutine was added to the codes to predict the heat pipe temperatures during a heat pipe failure accident. The results show that the heat pipe failure will cause larger temperature rises and stress concentrations. The heat pipe wall temperatures in the core differ from each other with the differences between the heat pipe loads during normal heat pipe operation and with failures reflecting the local effect of the heat pipe failures. The operating conditions far from the failure area are little affected (<20 K temperature change) by a single heat pipe failure. The effects of the heat pipe failure on the reactor core reactivity and local power distribution were also analyzed with a reactivity change of less than 5 pcm and a local power change of less than 0.1%. Therefore, the heat pipe failure can be analyzed in steady-state simulations with unchanged power distributions. (C) 2020 Elsevier Ltd. All rights reserved.

Analysis of the effect of equipment repair on system reliability

System-Level Reliability Analysis of a Repairable Power Electronic-Based Power System Considering Non-Constant Failure Rates

The Study on Effect of Random Maintenance Quality of Components on Composite Power System Reliability

A Failure Rate Model Analysis For Repairable System

Study on the System Simulation for the Heat Pipe Failure Transient of Heat Pipe Cooled Reactor

Failure Data Process Considering Trend of Failure Rate for Repairable Equipments in Nuclear Power Plants

Passive system accident scenario analysis by simulation

Imperfect Maintenance Scheduling for High Pressure Feedwater Heater System in Nuclear Power Plant

Effect Analysis of Power Supply Topology on the Reliability of the Reactor Protection System

Analysis on Fault Modes, Effect and Criticality of Reactor-Regenerator System in Fluid Catalytic Cracking Unit

Reliability Analysis and Availability Enhancements for Redundant Systems with Reparable Components

The Stress and Reliability Analysis of Htr'S Graphite Component

A Model for Passive System Reliability Analysis

Reliability Analysis of Nuclear Power Plant Electrical System Considering Common Cause Failure Based on GO-FLOW

STUDY AND RECOMMENDATIONS ON REPAIR STRATEGY IN THERMAL POWER PLANTS

Heat pipe failure accident analysis in megawatt heat pipe cooled reactor

Preliminary Research of Reactor Protection System Reliability Based on Monte Carlo Methods

Calculating Physical Failure Probability of Htr-10'S Residual Heat Removal System by Response Surface Method

Operational reliability assessment of power systems considering condition-dependent failure rate

Water Hammer Characteristics and Component Fatigue Analysis of the Essential Service Water System in Nuclear Power Plants

Effect of Coolant Water Temperature of ECCS on Failure Probability of RPV