Abstract:Mg-7Gd-1Y-xNd-0.3Zr alloys (x = 0, 2, 4 wt%) were subjected to multidirectional forging (MDF) and aging treatment to prepare a fine-grained microstructure, and the influence of Nd addition on the microstructure and mechanical properties was investigated. Increasing the Nd addition leads to the refinement of the grains in the Mg-7Gd-1Y-xNd-0.3Zr alloys after MDF deformation, as well as a weakening of the intensity of the texture. Moreover, the addition of Nd caused a significant amount of Mg3RE phase to remain on the grain boundary after MDF deformation, and facilitated the precipitation of the Mg5RE phase on the grain boundary during aging treatment. Following peak aging, the β' phase is characterized by a typical chain-like distribution, which is induced by dislocation at early aging. The distribution of precipitation on the grain boundary acts to strengthen the boundary, while promoting the formation of precipitate-free zones (PFZs) after aging, which enhances ductility. With the increase in Nd content from 0 to 2 and then to 4 (wt%), the ultimate tensile strength (UTS) and yield strength (YS) of the studied alloys initially increased, reached a peak in the Mg-7Gd-1Y-2Nd-0.3Zr alloy, and then declined, while the elongation (EL) gradually decreased. The increase in strength is primarily attributed to precipitation and solid solution strengthening, while the decrease in elongation arises from the large quantity of precipitation resulting from the addition of Nd. The addition of 2Nd (wt%) to the Mg-7Gd-1Y-0.3Zr alloy increased the UTS and YS of the alloy by 34 and 37MPa, and the EL decreased from 12.4% to 7.0%.

Influence of Nd and Y Additions on the Corrosion Behaviour of Extruded Mg-Zn-Zr Alloys

Effect of Nd on the Microstructure and Corrosion Behavior of Mg-Gd-Nd-Zr Alloys

Effect of Nd Addition on the Microstructure, Mechanical and Corrosion Properties of Mg-Zn-Y-Nd Alloys

Improvement of Corrosion Resistance of Mg-3Sn-2Al-1Zn Alloy by Heat Treatment and Y/Nd Addition

Effect of 0.45 Wt.% Nd Addition on the Corrosion Resistance of Extruded Mg-6Al-3Sn-2Zn Alloy

Microstructure and Mechanical Properties of Mg-7Zn-3Al Alloy with Nd and Y Additions

Effect of Trace Nd on Microstructure and Corrosion Resistance of AZ91 Magnesium Alloy

Microstructure and Salt Fog Corrosion of Wrought Mg-Al-Zn and Mg-RE Alloys

Influence of Neodymium on Microstructure and Corrosion Behavior of Mg‐8Li‐3Al‐2Zn Alloy

Comparative Study on Corrosion Behavior and Mechanism of As-Cast Mg–Zn–Y and Mg–Zn–Gd Alloys

Corrosive wear resistance of Mg-Al-Zn alloys with alloyed yttrium

Effect of Nd Addition on the Microstructure, Precipitate and Mechanical Properties of Mg-Gd-Y-(Nd) -Zr Alloys

Microstructure, Texture, and Mechanical Properties of Mg-Zn-Y-Nd-Zr Alloys

Effects of Minor Y Addition on Microstructure and Mechanical Properties of Mg-Nd-Zn-Zr Alloy

Effect of Neodymium Modification on the Corrosion Behavior of AZ63 Magnesium Alloy

Effect of Y Content on Corrosion Resistance of Mg-Zn-Y Alloys

Corrosion of Hot Extrusion AZ91 Magnesium Alloy. Part II: Effect of Rare Earth Element Neodymium (nd) on the Corrosion Behavior of Extruded Alloy

Effects of Rare Earth Yttrium on Microstructure and Properties of Mg-Al-Zn Alloy

Corrosion Behaviour and Electrochemistry of Mg-5Y-2Nd-0.5Zr-xSm (x=0, 1, 3 and 5) Alloys in 3.5 Wt.% NaCl

Influence of Yttrium Addition on the Corrosion Behaviour of As-Cast Mg–8Li–3Al–2Zn Alloy

Effects of Nd Addition on the Microstructure and Mechanical Properties of Extruded Mg-6Gd-2.5Y-0.5Zr Alloy