Abstract:We developed a synthetic method for amphiphilic and highly branched block copolymers composed of polystyrene and poly(N-isopropylacrylamide) (PNIPAM) through copolymerization of an anionic inimer (synthesized from monoaddition of 1,3-bis(1-phenylvinyl) benzene (MDDPE) with s-butyllithium) and styrene, followed by mechanism transformation from living anionic to controlled radical polymerization based on reversible addition-fragmentation chain transfer process. The mechanism transformation was achieved on the basis of conversion of living anionic species into thiocarbonylthio moieties by sequential reaction with CS2 and 1-phenylethyl bromide, affording a dendritic chain transfer agent (Dendritic-CTA). The resulting Dendritic-CTA was further employed to mediate RAFT polymerization of NIPAM to give amphiphilic and highly branched block copolymer. A series of amphiphilic and highly branched block copolymers were thus prepared by changing the feed ratio of NIPAM to Dendritic-CTA. The successful formation of Dendritic-CTA was confirmed by ultraviolet spectrum (UV), the structures of the Dendritic-CTA and the highly branched amphiphilic block copolymers were further characterized by H-1 nuclear magnetic resonance (H-1-NMR), gel permeation chromatography (GPC) equipped with multiangle laser light scattering detector. The solution properties of the highly branched amphiphilic block copolymers were investigated by fluorescence emission spectra (using nile red as the fluorescent probe), dynamic light scattering (DLS), and transmission electron microscopy (TEM). The fluorescence results show that the amphiphilic highly branched polymers have a low critical aggregation concentration (CAC) around 0.0035 mg/mL, and a temperature dependent multistage aggregation of the products in water was observed in the test of DLS. The DLS results also showed that the amphiphilic and highly branched block copolymers could form micelles with R-h size of 135 nm in water; the TEM results further illustrated that the amphiphilic and highly branched products could form spherical micelles and the diameters of the micelles were around 40 nm. Furthermore, the ability of the amphiphilic and highly branched products to stabilize the emulsion was studied using different oil/water systems. The results indicated a strong ability of emulsification arising from highly branched topology. Reversible formation of W/O and O/W was also observed due to the presence of PNIPAM segment with lower critical solution temperature (LCST). In addition, the emulsifying properties of the amphiphilic and highly branched products were closely dependent on the polarity of the solvents which were use to dissolved the polymers initially. The process may serve as a versatile approach to make amphiphilic and highly branched block copolymers with temperature responsiveness.

Synthesis of Amphiphilic Fluorinated Copolymer and the Formation of Hollow Nanotubes

Facile synthesis of nanocapsules and hollow nanoparticles consisting of fluorinated polymer shells by interfacial RAFT miniemulsion polymerization

A Facile Route to Synthesize Highly Uniform Nanocapsules: Use of Amphiphilic Poly(acrylic Acid)‐block‐polystyrene RAFT Agents to Interfacially Confine Miniemulsion Polymerization

Nanoencapsulation Via Interfacially Confined Reversible Addition Fragmentation Transfer (RAFT) Miniemulsion Polymerization

Aggregates of Amphiphilic Fluorinated Copolymers and Their Encapsulating and Unloading Homopolymer Behaviors

Synthesis and Surface Characterization of an Amphiphilic Fluorinated Copolymer Via Emulsifier-Free Emulsion Polymerization of RAFT

Synthesis and self-assembly of a novel fluorinated triphilic block copolymer

Synthesis and Solution-state Assembly or Bulk State Thiol-ene Crosslinking of Pyrrolidinone- and Alkene-functionalized Amphiphilic Block Fluorocopolymers: From Functional Nanoparticles to Anti-fouling Coatings

Facile Synthesis of Fluorescent ABA Type Amphiphilic Triblock Copolymers Via RAFT Polymerization and Their Aggregation Behavior in a Selective Solvent

Preparation of Miniemulsion and Nanocapsules by Reversible Addition-Fragmentation Chain Transfer and Chemical Shearing Method

PTPFCBBMA-b-PEG-b-PTPFCBBMA Amphiphilic Triblock Copolymer: Synthesis and Self-Assembly Behavior

Synthesis and micelle behavior of (PNIPAm-PtBA-PNIPAm)m amphiphilic multiblock copolymer

RAFT Polymerization-Induced Self-Assembly As a Strategy for Versatile Synthesis of Semifluorinated Liquid-Crystalline Block Copolymer Nanoobjects

Synthesis of Amphiphilic Highly Branched Block Copolymers Based on Mechanism Transformation from Anionic Polymerization into RAFT-based Polymerization

Direct Synthesis of Polymer Nanotubes by Aqueous Dispersion Polymerization of a Cyclodextrin/Styrene Complex.

Facile RAFT Precipitation Polymerization for the Microwave-Assisted Synthesis of Well-Defined, Double Hydrophilic Block Copolymers and Nanostructured Hydrogels

Hierarchical Self-Assembly of Triphilic Main-Chain-Type Semifluorinated Alternating Graft Copolymers in Aqueous Solution.

One-step Synthesis of Polymer Micro-Tubes Tethered by Polymer Nanowire Networks Via RAFT Polymerization of N ,N ′-Methylene Bisacrylamide Xerogel Fibers in Toluene and Ethanol Mixed Solution

Synthesis and self-assembly of amphiphilic gradient copolymer via RAFT emulsifier-free emulsion polymerization.

Synthesis, Characterization, and Self‐assembly of Amphiphilic Fluorinated Gradient Copolymer

The Recent Development in Synthesis of Amphiphilic Block Copolymers via RAFT Polymerization Method