Abstract:Purpose For moderate pressure and high pressure gear pumps, the temperature failure problem of bearings is now of considerable concern because of their heavy loads. However, the compact structure and the efficiency consideration make it extremely difficult to improve the bearing cooling. A self-circulating oil bearing system is developed for gear pumps with self-lubricating bearings to solve this problem. The oil is aspirated in from the low pressure chamber of the gear pump and discharged to the same chamber by using the pressure difference in the journal bearing, thus achieving the self-circulation. Design/methodology/approach An experiment test rig has been built for the feasibility study. The oil flow rate under different speeds has been recorded. Furthermore, the temperatures of the bearings with or without the oil circulation have been compared. Additionally, the oil flow in the test rig has been simulated using computational fluid dynamics codes. Findings The experimental and numerical results agree well. The experimental results indicate that the oil flow rate increases approximately linearly with the speed and the bearing temperature can be lowered successfully. The calculation results indicate that the bearing load capacity is nearly the same. Both the experimental and numerical studies establish that the self-circulating oil bearing system works successfully. Originality value As far as the authors know, it is the first time to find that the self-circulation can be built using the pressure difference in the bearing oil film, and this principle can be applied in the cooling and lubrication of the gear pumps to solve the temperature failure problem.

Failure condition analysis of tree-shaped distributed pump heating systems with a single heat source

Analysis of Superheater’s Pipe Wall Overtemperature by Fault Tree Diagnose

Simulation of distributed pump heating systems under failure conditions

Pressure pulsation analysis of runner and draft tube of pump turbine under different working conditions

Finite Long Body Source Model of Tube Group after Long-Time Heat Exchange in Ground Source Heat Pump

Analysis on Energy Saving of Distributed Circulating Pump Heat-supply System

Energy saving ratio of distributed water pump systems in tree networks with a single heat source

Energy-saving Analysis of Heat-supply System with Mult-stage Circulating Pump

Study on the Four-Quadrant Homologous Characteristic and Two-Phase Flow Head Degradation of a Reactor Coolant Pump

An Extension Theory-Based Fault Diagnosis Method for an Air Source Heat Pump

Experimental and Numerical Analysis of a Self-Circulating Oil Bearing System for Gear Pumps

Relationship between zero-pressure-difference point and transporting power in distributed pump heating systems

Study on Standby Hydraulic of Single-heat-source Single-looped District Heating Network

Hydraulic simulation and analysis of heating loop network with multi-heat source in faulty condition

Processing and Analysis of Reliability Data on Stator Cooling Pump

Feasibility analysis of circulating water-source heat pump heating system in power plant

Heat-supply network failure and measures for reliability improving

Failure Tree Analysis of Security System in Large Steam Turbine

Relationship Between Transport Power and Reliability of District Heating System

Analysis on Effectiveness of the Single-phase Natural Circulation Heat Sink of PHWR under Shutdown Conditions

Reliability assessment method of multi-heat source ring-shaped heat-supply networks