Abstract:The proper control of solder heating and melting leads to successful joining of surface-mount technology devices to the metallization of printed circuit boards. When developing new solder alloys for more miniaturized and lower temperature processes, the improved process control for the heating and melting during solder reflow can be beneficial. To find an optimized temperature profile efficiently, it is helpful to know the exact onset times of the physical mechanisms of soldering including sintering, melting, and solidification. In particular, to exactly know the time, the solder remains in the molten state can help to minimize the temperature exposure of sensitive substrates. To this end, we used standard lead-free SAC305 solder and a real-time resistance monitoring setup to observe the in-process resistance during the soldering of a 0805-type chip resistor to find out exact points in time when the soldering mechanisms occur. Cross-sectioning studies and microscopic observations were performed in parallel to explain three distinct resistance drops observed in the resistance signals. Sintering of solder balls resulted in drop 1, the collapse and melting of all the solder balls resulted in drop 2, and the solidification of solder resulted in drop 3, which actually consisted of two separate drops, one for each solder joint of the chip resistor. The observation of the resistance drop due to solder solidification was achieved because our newly improved setup reduced the signal noise to less than 0.012 m Omega (root mean square value). On average, the solder was in a liquid state for 17.6 min +/- 0.18 min (seven samples). The solidification drop was 0.2 m Omega and happened at approximately 200 degrees C, indicating not more than 28 K of undercooling. Such an accurate measurement of melting and solidification times may prove useful in the future when optimizing the reflow temperature profiles for advanced soldering applications, e.g., to minimize the melting-solidification interval on heat-sensitive thin flexible substrates for wearables.

Controlling And Optimization Of Thermal Profile In Reflow Soldering

Thermal profiling: a reflow process based on the heating factor

A Reflow Soldering Retro-Design System for Rework Station Based on Q-factor

On reflow soldering process and reflow profile

Optimization Method for Hot Air Reflow Soldering Process Based on Robust Design

Smarter Temperature Setup for Reflow Oven to Minimize Temperature Variation Among Components

Effects of the Solder Phase Transformation on the Optimization of Reflow Soldering Parameters and Temperature Profiles

Determination of Smarter Reflow Profile to Achieve a Uniform Temperature Throughout a Board

Test And Assessment Of The Heating System Of Reflow Ovens

Optimization simulation of reflow welding based on prediction of regional center temperature field

Temperature Modeling of Reflow Soldering Based on the Heat Transfer Mechanisms

Optimization and simulation of furnace temperature curve based on heat

SAC305 Solder Reflow: Identification of Melting and Solidification Using In-Process Resistance Monitoring

Analysis of residual stress after reflow soldering of QFN package

A Novel On-board Temperature Monitoring Approach in the Reflow Soldering Process

Reflow of Lead-Free Solder by Microwave Heating

Reliability Study on Thermal Cycling of QFP Device Solder Joints Based on Morphological Optimisation

Numerical investigations on the effects of different cooling periods in reflow-soldering process

Optimization of Control Parameters in Micro Hot Embossing