Abstract:We perform direct numerical simulations of a turbulent channel flow with a lubricated micro-grooved surface to investigate the effects of this surface on the slip characteristics at the interface and the friction drag. The interface between water and lubricant is assumed to be flat, i.e. the surface-tension effect is neglected. The solid substrate, where a lubricant is infused, is composed of straight longitudinal grooves. The flow rate of water inside the channel is maintained constant, and a lubricant layer under the interface is shear driven by the turbulent water flow above. A turbulent channel flow with a superhydrophobic (i.e. air-lubricated) surface having the same solid substrate configuration is also simulated for comparison. The results show that the drag reduction with the liquid-infused surface highly depends on the lubricant viscosity as well as the groove width and aspect ratio. The amounts of drag reduction with the liquid-infused surfaces are not as good as those with superhydrophobic surfaces, but are still meaningfully large. For instance, the maximum drag reduction by the heptane-infused surface is approximately 13 % for a rectangular groove whose spanwise width and depth in wall units are 12 and 14.4, respectively, whereas a superhydrophobic surface with the same geometry results in a drag reduction of 21 %. The mean slip length normalized by the viscosity ratio and groove depth depends on the groove aspect ratio. The ratio of fluctuating spanwise slip length to the streamwise one is between 0.25 (ideal surface without groove structures) and 1 (i.e. isotropic slip), indicating that the slip is anisotropic. Using the Stokes flow assumption, the effective streamwise and spanwise slip lengths are expressed as a function of groove geometric parameters and lubricant viscosity. We also suggest a predictive model for drag reduction with the heptane-lubricated surface by combining the predicted effective slip lengths with the drag reduction formula used for riblets (Luchini et al. , J. Fluid Mech. , vol. 228, 1991, pp. 87–109). The predicted drag reductions are in good agreements with those from the present and previous direct numerical simulations.

A Prediction of Drag Reduction by Entrapped Gases in Hydrophobic Transverse Grooves

Investigation of retention of gases in transverse hydrophobic microgrooved surfaces for drag reduction

Influence of entrapped gas morphology at liquid–solid interface on underwater drag reduction effect

Drag reduction on hydrophobic transverse grooved surface by underwater gas formed naturally

Maintenance of Air Layer and Drag Reduction on Superhydrophobic Surface

Influence of a Dynamic Gas Film on Underwater Drag Reduction

Maintaining Large-Scale Gas Layer by Creating Wettability Difference on Surfaces under Water

Drag Reduction by Microvortexes in Transverse Microgrooves

Simulation study of drag reduction of super hydrophobic surface in an unsteady flow

Slip theory-based numerical investigation of the fluid transport behavior on a surface with a biomimetic microstructure

On Interfacial Deformation and Resistance Characteristics over Superhydrophobic Surfaces: A Numerical Study

Computational Studies On Drag Reduction Effect By Surface Grooves

Macroscopic and Stable Gas Film Obtained by Superhydrophobic Step and Its Drag Reduction Performance

Numerical Study on Drag Reduction of Superhydrophobic Surfaces with Conical Microstructures in Laminar Flow

In Situ Grafting Hydrophilic Polymeric Layer for Stable Drag Reduction

Flow Characterizations and Drag Reduction on the Hydrophobic Surface with a Full Covering Gas Film

Underwater Drag Reduction by Gas

Transient velocity profiles and drag reduction due to air-filled superhydrophobic grooves

Experimental Study on the Drag Reduction Effect of a Rotating Superhydrophobic Surface in Micro Gap Flow Field

Drag reduction induced by superhydrophobic surfaces in turbulent pipe flow

Predictions of the effective slip length and drag reduction with a lubricated micro-groove surface in a turbulent channel flow