Abstract:The main objective of this paper is to study the behaviour and design of high strength steel columns at elevated temperatures using finite element analysis. In this study, equations predicting the yield strength and elastic modulus of high strength steel and mild steel at elevated temperatures are proposed. In addition, stress–strain curve model for high strength steel and mild steel materials at elevated temperatures is also proposed. The numerical analysis was performed on high strength steel columns over a range of column lengths for various temperatures. The nonlinear finite element model was verified against experimental results of columns at normal room and elevated temperatures. The effects of initial local and overall geometrical imperfections have been taken into consideration in the analysis. The material properties and stress–strain curves at elevated temperatures used in the finite element model were obtained from the proposed equations based on the material tests. Two series of box and I-section columns were studied using the finite element analysis to investigate the strength and behaviour of high strength steel columns at elevated temperatures. Both fixed-ended stub columns and pin-ended slender columns were considered. The column strengths predicted from the finite element analysis were compared with the design strengths predicted using the American, European and Australian specifications for hot-rolled steel columns at elevated temperatures by substituting the reduced material properties. In addition, the direct strength method, which was developed for the design of cold-formed steel columns at normal room temperature, was also used in this study to predict the high strength steel column strengths at elevated temperatures. The suitability of these design rules for high strength steel columns at elevated temperatures is assessed. Generally, it is shown that the American and European specifications as well as the direct strength method conservatively predicted the column strengths of high strength steel at elevated temperatures. The European Code predictions are slightly more conservative than the American Specification and the direct strength method predictions.

Behaviour of grouted sleeve connections at elevated temperatures

Impact Behaviours Of Concrete-Filled Steel Tubular Stub Column At Elevated Temperatures

Bond Performance of Seamless Steel Pipe Grouting Sleeves under Large-Deformation Repeated Tension and Compression after High Temperature

Tests on Impact Behaviour of Micro-Concrete-filled Steel Tubes at Elevated Temperatures Up to 400°C

Effects of Sustained Pre-Load on Residual Strength and Stiffness of Concrete-Filled Steel Tube after Exposure to High Temperatures

Strength of Concrete Filled Steel Tubes under High-Strain Rate Loading

EXPERIMENTAL RESEARCH ON IMPACT BEHAVIOR OF CONCRETE-FILLED STEEL TUBE AT ELEVATED TEMPERATURES

Experimental study on dynamic behavior of concrete at elevated temperatures

Post-Fire Mechanical Properties of Half-Grouted Sleeve Connectors with Grouting Defects

Behavior of High Strength Structural Steel at Elevated Temperatures

Behaviour of Endplate Joints Subjected to Elevated Temperature after Cyclic Loads

Experimental investigation of cold-formed steel material at elevated temperatures

Mechanical behavior of grouted sleeve connection for rebars in precast concrete structures and reliability analysis considering the ratio of anchorage length to rebar diameter

Comparative Analysis of the Performance and Study of the Effective Anchorage Length of Semi-Grouted and Fully-Grouted Sleeve Connection

Structural Performance of Grouted Sleeve Splice Connectors with Grooves Under Axial Tensile Load for Precast Concrete Structure

Mechanical Properties of Iron Tailing Sand Grout Sleeve Joints and Force Analysis

Analysis and Experimental Study on Mechanical Properties of Large-Diameter Grouted Sleeve Connections

Tensile behavior of half grouted sleeve connections: Experimental study and analytical modeling

Mechanical properties of butt weldments made with E5515-G electrodes at high temperature

Design of high strength steel columns at elevated temperatures

Behaviour Of Concrete-Filled Tubular T-Joints Under In-Plane Bending Cyclic Loading