Abstract:This article proposes a current path tracking approach that uses a current path state to correlate device status and operating mode of an inverter under normal and abnormal conditions. Based on graph theory, a node-path modeling method is proposed and applied in the T-type inverter topologies. The model reflects system state transitions, given healthy or faulted transistors. Effective conduction paths and node potentials can be derived with the model to indicate circuit faults. In addition, a hierarchical diagnosis method is proposed for single-transistor open-circuit (OC) faults based on estimated output voltage vectors. The diagnosis involves two steps. First, an OC fault can be detected by following a residual between an actual voltage vector and its reference voltage vector calculated from duty ratios of intended current paths. Next, faulty transistors sharing similar features can be distinguished by adopting a current path state reconfiguration approach. Diagnosis variables can be obtained from the controller, and their errors, because of sampling, signal delay, and dead time, are taken into account to avoid misdiagnosis. Experimental results verify the robustness and effectiveness of the proposed method.

Search of Topology Vector for Power Electronic Circuits

Topology Derivation of Transformerless Inverter Without Leakage Current Based on Graph Theory

Topology Identification for Power Electronic Circuits Based on Residual Analysis

FAULT DIAGNOSIS FOR POWER ELECTRONIC CIRCUITS BASED ON HYBRID SYSTEM THEORYAND EVENT IDENTIFICATION

A Voltage Vector Residual Estimation Method Based on Current Path Tracking for T-Type Inverter Open-Circuit Fault Diagnosis

Investigation on Different Compensation Topologies in Inductively Coupled Power Transfer System

Design Considerations of Compensation Topologies in ICPT System

Combinational Equivalence Checking Based on Circuit Topology Analysis

Analysis of a Three-Coil Series-Parallel-Series Topology Based on Asymmetrical Factor Method in Inductive Power Transfer System for Misalignment with Constant Current Output

Investigation on the Topology of Magnetic Sensor Arrays for High Current Measurements

A Fast Methodology for Topology Optimizations of Electromagnetic Devices

Tracing of the power system equilibrium solution manifold and searching for the instability bifurcation point

A Methodology Based on Quantum Evolutionary Algorithm for Topology Optimization of Electromagnetic Devices

Topological study and comprehensive analysis of power electronic circuit

A Combined Methodology Based on On/Off Method and Ga for Topology Optimization of Electromagnetic Devices

A Graph and Number Theory Based Description Method and Equivalence Judgment of Power Electronics Topology

Study on the New Topology of Power Electronic Transformer

Topology searching algorithm for multi-port hybrid circuit breakers based on graph theory

Power System State Identification Based on Set Theory Estimation Part Five Topology Error Identification

Condition diagnosis of process industry system with topology analysis based on complex network

Topology Error Identification With A Bounded-Error Modeling Of Measurements Uncertainty In Power System