Abstract:Gafchromic EBT (EBT) films are becoming increasingly popular due to their advantageous properties. When flatbed colour scanners are used for film dosimetry, a good quality control of the scanning device is a crucial step for accurate results. The proposal of this work was to fully assess the performance of the scanner Epson Expression 10000XL in order to quantify all parameters and needed corrections to minimize dose uncertainties. A standard step tablet, with 32 steps and optical densities from 0.06 to 3.8, was used to check the scanner linearity. The scanner warming-up effect and reproducibility were evaluated by performing 30 consecutive scans plus 20 scans in 15 min intervals. The scanning colour modes: 24 and 48 bits and scanning resolutions from 50 to 300 dpi were tested. A Wiener filter with different pixels regions was applied with the purpose of reducing the film noise. All scans were made in transmission mode with a constant film orientation. The red colour channel was posteriorly extracted from the images to maximize readout sensitivity. Two EBT films were irradiated, perpendicularly and parallel to beam incidence, with a 6 MV photon beam with doses that ranged from 0.2 to 3 Gy. A polynomial expression was used to convert optical density into dose. Dose uncertainty was quantified applying error propagation analysis. A correction for the non-uniform response of the scanner was determined using five films irradiated with a uniform dose. The scanner response was linear until an optical density of approximately 1 which corresponds to doses higher than those of clinical interest for EBT films. The scanner signal stabilized after seven readings. Scanner reproducibility around 0.2% was obtained either with the scanner warm or cold. However, reproducibility was significantly reduced when comparing images digitized with the scanner at different temperatures. Neither the colour depth mode, the scanning resolution, the multiscan option nor the Wiener filter had a significant effect on the shape of the calibration curve. However, a reduction in dose uncertainty was possible by selecting appropriate reading parameters. These are a 48 bit colour depth, a 75 dpi resolution and repeating the scan four times. Finally, the two dimensional Wiener filter applied to a 3 x 3 pixel region to the red component of the image reduced the experimental scan uncertainty to about 0.5% for doses higher than 0.5 Gy. Total scan uncertainty was less than 2% for a perpendicular calibration and reduced to less than 1% for a parallel calibration. A dose over-estimation of around 5% for clinical doses may be made if the image acquired is not corrected for the non-uniform response of the scanner. A protocol to read EBT films using the Epson Expression 10000XL scanner was established for IMRT verification. The contribution for the overall uncertainty in film dosimetry coming from the scanning process was estimated to be around 0.5% for doses higher than 0.5 Gy when reading parameters are optimized. Total scan uncertainty achieved is about 2% when using a perpendicular calibration. It can further be reduced if a parallel calibration is used.

Clinic Application of Epub of Medical Imaging Film in CT Workflow

Study of Archives Management and Transmission for DICOM Medical Images

Application of DICOM Electronic Film in Hospital Image Information System

EIR: Enterprise Imaging Repository, an Alternative Imaging Archiving and Communication System

The value of electronic film for improving the quality of hospital services]

Recovering medical images from CT film photos

CT Film Recovery via Disentangling Geometric Deformation and Illumination Variation: Simulated Datasets and Deep Models

Evaluation of an Epson flatbed scanner to read Gafchromic EBT films for radiation dosimetry

Automatic printing of hospital imaging film and its report: design and application

The Role of High-Energy Computed Radiography (CR) in Radiotherapy

Building and application of hospital's electronic film system]

Comprehensive evaluation and new recommendations in the use of Gafchromic EBT3 film

A patient-centric distribution architecture for medical image sharing

The Cost and Efficacy Analysis of PACS in Community Health Service Center

Clinical Utility of Gafchromic Film in an MRI-guided Linear Accelerator

[Diagnostic imaging and patient database managing systems: The integration of digital information in the experience of an intensive care center]

Paperless protocoling of CT and MRI requests at an outpatient imaging center

[Financial impact of introducing filmless CRT diagnosis]

Impact of Preset and Postset Adaptive Statistical Iterative Reconstruction-V on Image Quality in Nonenhanced Abdominal-Pelvic CT on Wide-Detector Revolution CT.

Development of an Electronic Portal Imaging Device Dosimetry Method

Foreign Exam Management in Practice: Seamless Access to Foreign Images and Results in a Regional Environment