Abstract:Viscometry is an often applied method in clinical chemistry. A variety of studies demonstrate an association of parameters related to blood viscosity with human pathology of varying origin. Whole blood and plasma viscosity are considered to be clinically useful indicators in the diagnostic workup and therapy monitoring of certain diseases. In this study, we compare the "Waegeviskosimeter" (WV) described in previous publications with a newly developed device, the "Reverse Flow Viscometer" (RFV). Both viscometers are capillary flow viscometers. Both overcome the disadvantage of common viscometers of the Ubbelohde and Cannon-Fenske type which require large amounts of plasma and which can be only applied to Newtonian fluids. The accuracy of the measurements of both viscometers, requiring less than 1.0 ml sample volume, is superior to most conventional methods. The major distinction in the functionality of the WV and the RFV is that the WV measures the kinematic viscosity whereas the RFV directly estimates dynamic viscosity without the requirement of additional density measurement. We found good reproducibility of viscosity with coefficient of variation CV < or =1.1% for both viscometers. Quality assurance measures have been carried out. Because no quality assurance scheme according to the guidelines proposed by the German Medical Association exists for plasma or whole blood viscosity, we tested reference material Lyphochek Unassayed Chemistry Control Level 1 and Level 2 (Bio-Rad Laboratories). We determined the viscosities 1.40 mPa s and 1.08 mPa s (37 degrees C) and the between-run precision from daily quality control runs with CV of 1.4% and 1.2% for the WV, and 1.7% and 1.4% for the RFV. For direct comparison reasons, we determined the viscosity in seventy human plasma and serum samples by both methods. Using the regression analysis described by Passing-Bablok, the RFV and the WV methods are highly correlated and show only little variations (r = 0.990, tau = 0.896). The regression equation is y(WV) = 1.035x(RFV) - 0.056 with a mean deviation of 0.4+/-3.6%. We conclude that both new devices for viscosity assessment fulfill all quality requirements as prescribed for clinical chemical laboratories. One advantage RFV is to measure the dynamic viscosity directly.

Measurement of hemo-rheological properties with novel rotational capillary viscometer

Microrheology study on relation between blood viscosity and electric resistivity

MEASUREMENT OF RBC RHEOLOGICAL BEHAVIOURS WITH IMPEDANCE METHOD

Comparative evaluation of two newly developed devices for capillary viscometry

Development of a Viscosity Measuring Device for Low Boiling Point Refrigerant Mixtures

Electromagnetically spinning viscometer designed for measurement of low viscosity in low shear rate region

Numerical assessment of the penetroviscometer approach for large, rapid and transient shear deformations

Measurement of the Viscosity of Dilute Magnetic Fluids

Rapid measurement of fluid viscosity using co-flowing in a co-axial microfluidic device

Torque Modification of a New Couette Rheometer and Error Analysis of the Viscosity Measurement

Viscometer for investigating the viscosity of magnetic fluid media

Research and Application of Film Gap Couette Rheometer with Flow Visualization and Pressure Control

A New Method for Liquid Viscosity Measurements: Inclined-Tube Viscometry

A Novel Approach to Measure Froth Rheology in Flotation

Measurement of the flow behavior index of Newtonian and shear-thinning fluids via analysis of the flow velocity characteristics in a mini-channel

Design and Fabrication of a Microfluidic Viscometer Based on Electrofluidic Circuits

Shear rate induced viscosity change of human blood samples and blood mimicking fluids

A METHOD FOR LIQUID VISCOSITY COEFFICIENT MEASUREMENT USING INCLINED TUBE

Limits for safe viscosity measurement of non-colloidal suspensions in rotational rheometry—a numerical simulation-based approach

Rheological synergistic thermal conductivity of CMC-based Fe3O4 and Al2O3 nanofluids in shear flow fields

Measurement method of residence time distribution for high viscous fluids based on the gray-scale analysis