Abstract:This article proposes a hierarchical collaborative reactive power and voltage control method aimed at meeting the internal voltage requirements of a coupled system composed of centralized new energy stations such as wind and solar power and traditional thermal power units, with particular attention paid to the reactive power regulation ability of power units in new energy stations. This method is implemented in two layers: At the transmission layer, the overall reactive power compensation capacity of thermal power units and stations on the transmission lines within the system is determined according to the engineering requirements of different node voltages in the coupled system, the regulation voltages of the high-voltage grid-connected points and the point of common coupling (PCC) of the stations are found, and the actual regulation voltages of the PCCs of the stations are given as commands. At the station layer, based on determining reactive power distribution between power units and continuous reactive power compensation devices within each station, voltage optimization is carried out using the voltage command issued by the transmission layer as a reference. At the same time, consistency coordination between the transmission layer and the station layer is achieved based on the Analytical Target Cascading (ATC) method at different layers. Finally, simulation analysis was conducted on a regional coupled system in Dalian. The results showed that the method proposed in this paper can effectively control the voltage safety requirements of each region and PCC in the coupled system and, to some extent, improve the economic efficiency of system operation.

Analysis and Control of Reactive Circular Power Flow in Looped Electromagnetically Coupled Power Networks

Research and analysis of power transfer based on multiple electromagnetic looped network

Power Coupling Analysis and Improved Decoupling Control for the VSC Connected to a Weak AC Grid

Study on Networked Control for Power Electronic Systems

Analysis of effects on the Ningxia power system arising from electromagnet coupled networks operating at different voltage level

Model Predictive Control of LPC-Looped Active Distribution Network with High Penetration of Distributed Generation

A Closed Loop Operation Analysis Software Based on the Integrated Model of the Entire Power Grid

Research on the Solution of Electromagnetic Loop Network

A VSC-HVDC Based Flexible Controller for Improving the Performance of Looped Electromagnetic Networks in Guangzhou Power Grid

Research on Loop-Closing Strategy of Two-Way Active Distribution Network Based on Power Flow Controller

Coordinated Control of Power System Based on Direct Neural Dynamic Programming Method

Research on Reconstruction Method of Multi-terminal Electromagnetic Loop Networks

Research on Hangzhou 10 Kv Distribution Network Closing Loop Operation

Loop Closing Examination and Analysis on Beijing 10 Kv Distribution Network

Effects Analysis of Excitation Circuit on Power Control for Virtual Synchronous Generator: A Design-Oriented Study

Analysis of Dynamic Stability Characteristics of 750 Kv Northwest China Power Grid and Research on Its Control Strategy

Equivalent substitution method-based failures analysis for electromagnetic loop

Collaborative Control of Reactive Power and Voltage in a Coupled System Considering the Available Reactive Power Margin

Research on coordinated control strategy for reactive power and voltage in distribution network

Operation mode of 10 kV distribution network with flexible looped network controller

Study on open-loop planning of 220 kV electromagnetic ring in Zhengzhou