Abstract:The wastewater containing high concentration (5562.71mg/L) of nickel ion was first completely precipitated at pH 9, and subsequently treated by a ceramic microfiltration membrane with a pore diameter of 0.5μm. During the concentration process, the membrane flux (J) dropped significantly at the initial stage, then declined slowly, and finally decreased at a rapid rate again. The nickel rejection coefficient (RNi) was found to be approx. 1. When the volume concentration factor (VCF) increased from 1to 10, the nickel concentration in the retentate (Cr) increased from 5562.71 to 55507.76mg/L, whereas the nickel concentration in the permeate (Cp) remained nearly constant at approx. 13.26mg/L. Then, the complexation-ultrafiltration process was studied using the permeation fluid from the microfiltration process as the feed solution. Poly (ethylene imine) was employed as the complexing agent. The effects of the polymer/metal mass ratio (rp/m), pH, temperature and operating pressure on RNi and J were investigated. Further, the process of ultrafiltration concentration was studied. The results showed that RNi increased with increasingrp/m or pH and decreased slightly with temperature, and that the operating pressure exerted no effect on RNi;J increased with temperature or operating pressure. With increasing pH,Jincreased at first, and then reached a constant value. The effect of rp/m on J was insignificant. The ultrafiltration concentration experiment was carried out at rp/m=7 and pH=9. When VCF increased from 1to 30,J only declined by 9.76%.Cr increased linearly from 13.26to 396.64mg/L, whereas Cp remained roughly unchanged at about 0.04mg/L. Nickel ions were concentrated effectively, and the permeation solution from the ultrafiltration process was discharged directly.

Treatment of Wastewater Containing Chromium Ions with Nanofiltration Membrane

Negatively-charged Nanofiltration Membrane and Its Hexavalent Chromium Removal Performance.

The Efficient Removal of Low Concentration Hexavalent Chromium Via Combining Charged Microporous Membrane and Micellar Adsorption Filtration

Removal of Hexavalent Chromium from Wastewater by Cu/Fe Bimetallic Nanoparticles

Preparation and Characterization of Novel Polyvinylidene Fluoride/2-Aminobenzothiazole Modified Ultrafiltration Membrane for the Removal of Cr(VI) in Wastewater

Removal of Hexavalent Chromium(VI) from Wastewater Using Chitosan-Coated Iron Oxide Nanocomposite Membranes

Removal of Cr (VI) with a Spiral Wound Chitosan Nanofiber Membrane Module Via Dead-End Filtration

Fabrication of Asymmetric Poly (M-Phenylene Isophthalamide) Nanofiltration Membrane for Chromium(vi) Removal

Chromium Removal Using Resin Supported Nanoscale Zero-Valent Iron.

Biofouling/acid resistant nanofiltration membranes interfacially polymerized with nickel-doped carbon dots for highly efficient removal and real-time monitoring of chromate in wastewater

Hexavalent Chromium Removal from Model Water and Car Shock Absorber Factory Effluent by Nanofiltration and Reverse Osmosis Membrane

Hybrid Nanofiltration–membrane Crystallization System for the Treatment of Sulfate Wastes

Sodium alginate encapsulated nano zero valent iron loaded in aminated magnesium hydroxide for effective removal of chromium

Ultrafiltration membrane for effective removal of chromium ions from potable water

Removal of Chromium(Vi) from Wastewater by Combined Electrocoagulation-Electroflotation Without A Filter

Treatment of Wastewater Containing High Concentration Nickel Ions with Precipitation-Microfiltration-complexation-ultrafiltration Processes

Removal of chromium(VI) from wastewater by nanoscale zero-valent iron particles supported on multiwalled carbon nanotubes

Preparation of Nano-Iron Loaded Cassava Fibre Composite Material for Hexavalent Chromium Removal

CONCENTRATION AND SEPARATION NICKEL WASTEWATER BY NANOFILTRATION

Preparation, characterization and performance of an electrospun carbon nanofiber mat applied in hexavalent chromium removal from aqueous solution