Abstract:Rare-earth-doped SiAlON and Si3N4 materials from aluminosilicate starting materials have been reported to show superior photoluminescence (PL) properties. Three different starting materials, including pulverized coal furnace fly ash, diatomite and raw illite, were used for synthesis of nitride materials. The phase and morphology evolution of these products were carefully monitored at the low temperature range of 1350 °C to 1450 °C by X-ray diffraction (XRD), scanning electronic microscopy (SEM) and Fourier-transform infrared spectroscopy (FT-IR). The PL properties of Eu-doped nitride products were also comparatively characterized. The results show that the type of starting material affects the phase composition and the photoluminescence properties of products. The existence of aluminum and alkali metals could effectively promote nitridation reactions. Aluminum in the starting materials led to the formation of different aluminum-rich nitride phases. Thus, β-SiAlON could be achieved at a much lower temperature (1350 °C) using raw illite or fly ash containing the proper amount of aluminum. Additionally, excess aluminum led to the formation of corundum and 15R-SiAlON. The products from pulverized coal furnace fly ash had more prismatic particles, and the products from diatomite had more fibrous particles. With the progress of the nitridation process, the fibers were increased, becoming longer and straighter, and the prismatic particles were more obvious. The presence of aluminum in the starting materials led to a blue shift in the photoluminescence spectrum.

Preparation of Eu2+-doped AlN Phosphors by Plasma Activated Sintering

Preparation and Photoluminescence Properties of Eu3+-Doped Al2O3 Films on Silicon Substrates by the Sol-gel Method

Novel Optical Characteristics of Eu2+doped and Eu2+, Ce3+co-doped LiSi2N3phosphors by Gas-Pressed Sintering

Study on preparation mechanism and luminescence property of CaAlSiN3: Eu phosphor

Synthesis, structure, and luminescence properties of SrSiAl<sub>2</sub>O<sub>3</sub>N<sub>2</sub>:Eu<sup>2+</sup> phosphors for light-emitting devices and field emission displays

Preperation and Photoluminescent Properties of Ca2AlSi3O2N5:Sm3+ Phosphor

Carbothermal Reduction Nitridation of Fly Ash, Diatomite and Raw Illite: Formation of Nitride Powders with Different Morphology and Photoluminescence Properties

Effect of Comburent Ratios on Combustion Synthesis of Eu-doped Β-Sialon Green Phosphors

The pure-phase Ba3−xCaxSi6O12N2:Eu2+ green phosphor: synthesis, photoluminescence and thermal properties

SHS of Eu2+-doped Β-Sialon Phosphors: Impacts of N2 Pressure and Si Particle Size

Synthesis of CaAlSiN3:Eu2+ Nitride Phosphors from Entire Oxides Raw Materials and Their Photoluminescent Properties

Micro-spherical MAl2O4: Eu2+ (m=ca; Sr) Phosphors: Fast Sol-Gel Route to Monodisperse Size Distribution and Monoclinic Lattice Structure to High Efficiency

Thermal-Insulation-Assisted Combustion Synthesis of Ca-alpha-SiAlON:Eu2+ Phosphors

Luminescence Properties of Ca2si5n8:Eu2+ Prepared by Gas-Pressed Sintering Using Baf2 As Flux and Cation Substitution

Synthesis of G-La2Si2O7:Eu2+ phosphors by addition of AlF3: Experimental and theoretical analysis

Impact of Si/Al Ratio in Comburents on the Combustion Synthesis of Eu2+-doped Α-Sialon Yellow Phosphors

Combustion Synthesis of Eu2+Doped Β-Sialon Phosphors by Salt Assistance

Effective Suppression of AlN Impurity in Synthesis of CaAlSiN 3 :Eu 2+ Phosphors under Condition of Atmospheric Pressure

Effect of Starting Composition and Post-Anneal on the Structure and Luminescence Properties of Eu-doped Ca-α-SiAlON Phosphors Prepared by Combustion Synthesis

Improved Luminescence and Afterglow Emission from Mn2+/Si4+ Co-Doped AlN by Combustion Synthesis Method

Enhancing the Emission Intensity and Decreasing the Full Widths at Half Maximum of Ba3Si6O12N2:Eu(2+) by Mg(2+) Doping.