Abstract:OBJECTIVE:To investigate the changes of the vertical height and width of the alveolar bone six months after the alveolar ridge preservation in periodontal compromised molar sites of severe alveolar bone defects with clinical direct measurement, parallel periapical radiographs, and cone-beam computed tomography (CBCT), and to analyze the effect of the three different methods of measurement. METHODS:In this study, 20 subjects requiring tooth extraction on account of periodontal disease with a total of 23 extracted molars were enrolled. Extractions were performed atraumatically and patients were received alveolar ridge preservation procedure with Bio-Oss and Bio-Gide. Clinical direct measurements were taken after tooth extraction and during the implant surgery 6 months later, CBCT scans and parallel periapical radiographs were taken immediately after ridge preservation and 6 months later. The changes of alveolar ridge width and vertical height after six months were measured and analyzed through the above-mentioned three methods and the similarities and differences of the measured effect were compared. RESULTS:There were no significant difference of alveolar vertical height in the center of the extraction sites, the center of distal aspect, and distobuccal aspect between the clinical direct measurements and the CBCT measurements (P>0.05), alveolar vertical height in other points and alveolar width measurements were statically significant (P<0.05). After 6 months, 10 sites of 10 subjects were received a flap and re-entered to perform dental implants surgery. The vertical height in the center of alveolar increased significantly and the changes of alveolar vertical height of clinical direct and CBCT measurement were (6.15 ± 1.73) mm and (6.59 ± 2.53) mm, respectively. The measurements of the width of the alveolar bone were (8.45 ± 1.18) mm and (8.52 ± 1.27) mm, respectively. The measurements of the two methods were not statistically significant (P>0.05). The change of the alveolar height in the center of the extraction socket after six months measured by parallel periapical was (5.84 ± 4.28) mm, which was closed to the clinical direct measurement and the CBCT measurement. CONCLUSION:Clinical direct measurement and CBCT measurement were largely consistent in the evaluation of the alveolar bone height and width after the alveolar ridge preservation using deproteinized boving bone mineral (DBBM, Bio-Oss) and bioabsorbable collagen membrane (Bio-Gide) in periodontal compromised molar sites of severe bone defects.

Preliminary Evaluation of Grey Values for Scaling the Change of Alveolar Bone Density

Facial alveolar bone alterations and gray value changes based on cone beam computed tomography around maxillary anterior implants: A clinical retrospective study of 1-3 years

Bone Volume and Height Changes for Lateral Window Sinus Floor Elevation Using Two Types of Deproteinized Bovine Bone Mineral: A Retrospective Cohort Study of 1-4 Years

[A system for quantitatively measurement of alveolar bone density and the evaluation of its precision and validity].

Progressive Comparison of Density Assessment of Alveolar Bone Graft in Patients with Unilateral and Bilateral Cleft

Feasibility analysis of bone density evaluation with Hounsfield unit value after fibula flap reconstruction of jaw defect

Application of CBCT in evaluation of alveolar bone changes before and after periodontal therapy in chronic periodontitis

[Evaluation with Different Measuring Methods for the Alveolar Bone Change of Ridge Preservation in Molar Sites].

Radiographic Assessment of Deproteinized Bovine Bone Mineral (DBBM) and Collagen-Stabilized DBBM for Transalveolar Sinus Floor Elevation: A 2-Year Retrospective Cohort Study

Accuracy and sensibility of computer -aided alveolar bone density quantitative measuring system]

Changes in alveolar bone density around immediate functionally and nonfunctionally loaded implants

Evaluation of the clinical efficacy and safety of modified alveolar cleft bone graft with cone-beam CT digital imaging in children

Assessment of the Bone Mineral Content in the Mandible by Dual-Energy X-Ray Absorptiometry to Evaluate Short-Term Change.

Gray value measurement for the evaluation of local alveolar bone density around impacted maxillary canine teeth using cone beam computed tomography

Clinical characteristics associated with bone mineral density improvement after 1-year alendronate/vitamin d3 or calcitriol treatment: Exploratory results from a phase 3, randomized, controlled trial on postmenopausal osteoporotic women in China.

Clinical characteristics associated with bone mineral density improvement after 1-year alendronate/vitamin d3 or calcitriol treatment

Digital radiographic evaluation of alveolar bone loss, density and lamina dura integrity on post splinting mandibular anterior with chronic periodontitis

Evaluation of the Clinical Effects of Two Different Scalers Used in Subgingival Scaling

Comparison of the Measurement Result of Available Alveolar Bone Based on Two Different Graphical Methods

Application of sticky bone combined with concentrated growth factor (CGF) for horizontal alveolar ridge augmentation of anterior teeth: a randomized controlled clinical study

Changes of alveolar bone dehiscence and fenestration after augmented corticotomy-assisted orthodontic treatment: a CBCT evaluation