Abstract:OBJECTIVE:To investigate the changes of the vertical height and width of the alveolar bone six months after the alveolar ridge preservation in periodontal compromised molar sites of severe alveolar bone defects with clinical direct measurement, parallel periapical radiographs, and cone-beam computed tomography (CBCT), and to analyze the effect of the three different methods of measurement. METHODS:In this study, 20 subjects requiring tooth extraction on account of periodontal disease with a total of 23 extracted molars were enrolled. Extractions were performed atraumatically and patients were received alveolar ridge preservation procedure with Bio-Oss and Bio-Gide. Clinical direct measurements were taken after tooth extraction and during the implant surgery 6 months later, CBCT scans and parallel periapical radiographs were taken immediately after ridge preservation and 6 months later. The changes of alveolar ridge width and vertical height after six months were measured and analyzed through the above-mentioned three methods and the similarities and differences of the measured effect were compared. RESULTS:There were no significant difference of alveolar vertical height in the center of the extraction sites, the center of distal aspect, and distobuccal aspect between the clinical direct measurements and the CBCT measurements (P>0.05), alveolar vertical height in other points and alveolar width measurements were statically significant (P<0.05). After 6 months, 10 sites of 10 subjects were received a flap and re-entered to perform dental implants surgery. The vertical height in the center of alveolar increased significantly and the changes of alveolar vertical height of clinical direct and CBCT measurement were (6.15 ± 1.73) mm and (6.59 ± 2.53) mm, respectively. The measurements of the width of the alveolar bone were (8.45 ± 1.18) mm and (8.52 ± 1.27) mm, respectively. The measurements of the two methods were not statistically significant (P>0.05). The change of the alveolar height in the center of the extraction socket after six months measured by parallel periapical was (5.84 ± 4.28) mm, which was closed to the clinical direct measurement and the CBCT measurement. CONCLUSION:Clinical direct measurement and CBCT measurement were largely consistent in the evaluation of the alveolar bone height and width after the alveolar ridge preservation using deproteinized boving bone mineral (DBBM, Bio-Oss) and bioabsorbable collagen membrane (Bio-Gide) in periodontal compromised molar sites of severe bone defects.

Digital radiographic evaluation of alveolar bone loss, density and lamina dura integrity on post splinting mandibular anterior with chronic periodontitis

Healing in periodontal defects treated by decalcified freeze-dried bone allografts in combination with ePTFE membranes. Assessment by computerized densitometric analysis

Effects of nonsurgical periodontal treatment on the alveolar bone density.

Three-D Imaging of Dental Alveolar Bone Change after Fixed Orthodontic Treatment in Patients with Periodontitis.

Evaluating the effects of splinting implant scan bodies intraorally on the trueness of complete arch digital scans: A clinical study

Alveolar Bone Morphology Following Periodontally Accelerated Osteogenic Orthodontics: A Clinical and Radiographic Analysis.

Assessment of Alveolar Bone Status of Periodontally Involved Teeth After Socket Augmentation Using Xenograft and Platelet Rich Fibrin: A Randomized Controlled Clinical Trial

Extra oral digital scanning and imaging superimposition for volume analysis of bone remodeling after tooth extraction with and without 2 types of particulate porcine mineral insertion: A randomized controlled trial

Survival of Nonsurgically Splinted Mandibular Anterior Teeth During Supportive Maintenance Care in Periodontitis Patients.

Long-term changes in the anterior alveolar bone after orthodontic treatment with premolar extraction: a retrospective study.

[Evaluation with Different Measuring Methods for the Alveolar Bone Change of Ridge Preservation in Molar Sites].

Alveolar regeneration of the post-extraction site with cortical deficiency using the Lamina Socket Sealing technique: Retrospective study with histomorphometric analysis of regenerated bone and evaluation of soft tissue changes. Part 2/2

Combined use of xenogeneic bone substitute material covered with a native bilayer collagen membrane for alveolar ridge preservation: A randomized controlled clinical trial.

Clinic evaluation of the ribbon reinforced resin splinting mobile mandibular anterior teeth

Periodontal Membrane and Alveolar Bone Resorption: a Pilot Study

Changes in alveolar bone density around immediate functionally and nonfunctionally loaded implants

Finite Element Analysis on Loosen Teeth Using Fibrous Periodontal Splint Restoration

Clinical and radiographic evaluation of demineralized freeze-dried bone allograft with concentrated growth factor versus concentrated growth factor alone in the treatment of intrabony defects

Five-year radiological findings from a randomized controlled trial of four periodontitis treatment strategies.

Evaluation on mandibular bone mineral density of periodontitis patients with digital panoramic radiograph

Three-dimensional Analysis of Alveolar Bone with and Without Periodontitis