Abstract:In this paper, the influences of Cr3C2/VC content on WC grain size, WC grain shape and mechanical properties of WC–6 wt. % Co cemented carbides were investigated. The results showed that the grain size first rapidly decreased and then slightly decreased with the increasing Cr3C2/VC content, and VC led to finer grain size and narrower size distribution. HRTEM/EDS analysis of the WC/Co interface indicates that the segregation concentration of V is much larger than that of Cr, which may be a strong response to the higher inhibition efficiency of VC. The addition of Cr3C2 induced triangular prism shape WC grains while VC generated stepped triangular prism grains. Despite the grain growth inhibitor (GGI) mechanisms of Cr3C2/VC have been extensively studied in the literature, the doping amount, especially the doping limit, has not been systematically investigated. In this work, the saturated solubilities of Cr and V in cobalt binder phase along with carbon content hare been predicted based on thermodynamic calculations. Based on the theoretical calculations, the doping amount of Cr3C2/VC is designed to be gradually increasing until more or less over their maximum solubilities in the binder phase, thereby investigating the subsequent microstructure and mechanical properties. When the doping of Cr3C2/VC exceeds the maximum solubility in Co phase, Co-rich Cr-carbides and Co-deficient V-carbides would form respectively, which were detrimental to the transverse rupture strength (TRS) and impact toughness. The hardness increased with the increasing Cr3C2/VC content, while the fracture toughness decreased with the increasing Cr3C2/VC content. The TRS initially enhanced and then declined, but the stepped triangular prism shape grains and low fraction of WC/Co interface in WC–6Co–VC cemented carbide led to a more pronounced decline in the TRS. The sample with 0.6 wt. % Cr3C2 addition had good comprehensive mechanical properties, its hardness, fracture toughness and TRS were 1880 kg/mm2, 9.32 MPa·m1/2 and 3450 MPa, respectively.

Growth Mechanisms of WC in WC–5.75 Wt% Co

Microstructure Evolution in the Cemented Carbides Wc-Coi. Effect of the C/W Ratio on the Morphology and Defects of the Wc Grains

Growth Mechanism of In-Situ WC Grain in Fe-Ni-W-C Alloys System

Abnormal Grain Growth of WC with Small Amount of Cobalt

Low-energy grain boundaries in WC-Co cemented carbides

Complexions in WC-Co Cemented Carbides

Microstructure and Formation Mechanism of WC Coating on Tungsten Fabricated by Interstitial Carburization: A Multiscale Investigation

Influence of Cr3C2 and VC Content on WC Grain Size, WC Shape and Mechanical Properties of WC–6.0 wt. % Co Cemented Carbides

Microstructural study on the grain growth inhibition of VC-doped WC-Co cemented carbides

Coprecipitation of co and La 2 O 3 coprecipitation on WC for tailoring the grain distribution and boundary of high-performance coarse-grained WC-10Co cemented carbide

Effect of carbon content on the properties of inhomogeneous cemented carbides with fine-grained structures produced via one-step transformation

Effect of initial WC particle size on grain growth behavior and gradient structure formation of bilayer functionally graded cemented carbides

Effect of particle size and high-energy ball milling time on microstructure and mechanical properties of WC-10Co cemented carbides with plate-like WC grains

Hardening and toughening mechanisms of cemented carbides with plate-like WC grains prepared by seeding

Ultra-coarse cemented tungsten carbide with (Zr,W)C x precipitates in ceramic phase

Evaluation of microstructure and growth kinetics of tungsten carbide ceramics at the interface of iron and tungsten

Ultra-coarse Cemented Tungsten Carbide with (zr,w)cx Precipitates in Ceramic Phase

Role of Co Content on Densification and Microstructure of WC–Co Cemented Carbides Prepared by Selective Laser Melting

Crystal Defects Responsible for Mechanical Behaviors of a WC-Co Composite at Room and High Temperatures - a Simulation Study.

Effect of chromium doping on the grain boundary character of WC-Co

EBSD study to analyse mechanisms of phase boundary and grain boundary development in WC-Co cemented carbides