Abstract:In a switchgear, an external transverse magnetic field (ETMF) is generated by the U type loop consisting of the vacuum interrupter, external busbar and conductive rod connected to the vacuum interrupter. The ETMF will make the vacuum arc deflected and strengthen the contraction of the arc. This can increase the probability of breaking failure. To weaken the adverse effect of the ETMF, the real magnetic field data of the arc area with different structure parameters when the length of conductive rod, external busbar and phase distance is changed are obtained by establishing simulation model in this paper. Taking the real magnetic field data as the boundary condition, this paper obtains the typical parameters of the vacuum arc plasma with different structure parameters by using the established three-dimensional high-current vacuum arc magnetohydrodynamics model. The simulation results show that the ETMF makes the transverse magnetic field (TMF) of the arc area asymmetric, which leads to an arc deflection. Reducing the length of the conductive rod connected to the vacuum interrupter to 50 mm can effectively improve the asymmetry of the TMF caused by the EMTF, weaken the arc deflection phenomenon, make the distribution of the plasma parameters more uniform, and increases the utilization of the anode contact surface. Moreover, it can not only reduce the heat flux density into the anode as a whole, but also reduce the heat flux density in the high heat flux density area, so as to effectively reduce the degree of anode activity and improve the negative effects caused by the anode activity. The changes of other external structural parameters have less influence on the improvement of the vacuum arc deflection phenomenon. Increasing the phase spacing to 275 mm or reducing the length of the external bus bar to 100 mm can only slightly weaken the arc deflection.

Study Of The Effect Of Gassing Material On Are Behavior In Low Voltage Circuit Breaker

Simulation of the Effects of Several Factors on Arc Plasma Behavior in Low Voltage Circuit Breaker

Simulation on the Air Arc Characteristcs Concerning the Influence of Wall Ablation

Study of the Influence of Arc Ignition Position on Arc Motion in Low-Voltage Circuit Breaker

Simulation and Experiment on Airarc Characteristics in Low-Voltage Circuit Breaker Considering Wall Ablation

Simulation Experiments and Research of Arc for Low Voltage Circuit Breaker

Experimental Study of the Influence of Gassing Material on Blow Open Force and Arc Motion

Simulation of the Venting Configuration Effects on Arc Plasma Motion in Low-Voltage Circuit Breaker

The Influence of Medium on Low-Voltage Circuit Breaker Arcs

Simulation and Experimental Research on Air Arc Motion in Low-voltage Circuit Breaker

Simulation of the Process of Arc Energy-Effect in High Voltage Auto-Expansion Sf6 Circuit Breaker

Simulation and Experimental Study of Arc Motion in a Low-Voltage Circuit Breaker Considering Wall Ablation.

Numerical Study on Arc Plasma Behavior During Arc Commutation Process in Direct Current Circuit Breaker

Particle-in-cell/Monte Carlo Collision Simulation on Gap Breakdown Characteristics of under the Conditions of Hot-Electrode and High-Temperature Gas Medium in Low-Voltage Circuit Breaker Chamber

Modelling of the Interruption Process in Sf6 High Voltage Circuit Breaker and Preliminary Study of the Arc Characteristics for Different Gases

Simulation of Arc Characteristics in Miniature Circuit Breaker

Research of simulation and experiment on arc characteristics of gas mechanical switch

2D Arc Modeling and Simulation of SF6 Circuit Breaker Based on Magnetohydrodynamics

Numerical Investigation on the Influence of Circuit Breaker Structure Parameters on Vacuum Arc Behaviors

Simulation and Experimental Research on Air Are Movement Characteristics in Low-voltage Circuit Breaker Considering Electrodes Erosion

Influence of Copper Vapor on Low-Voltage Circuit Breaker Arcs During Stationary and Moving States