Abstract:Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications, Ahead of Print. The work reports on synthesis and comprehensive evaluation of different properties of a bilayer protective coating on Mg alloy of AZ91D grade. Initially the alloy substrates were treated in stannate bath for 15, 30, 45, 60, 75 and 90 min for synthesizing an MgSnO3.3H2O layer. Electroless Ni-P was then deposited for 30 and 60 min, on the stannate layer synthesized for 60 min. A time-dependent cyclic growth behaviour was observed for stannate layers, characterized by formation and dissolution of MgSnO3.3H2O globules. The stannate coatings displayed polycrystalline structure. Hardness and scratch resistance were strongly influenced by uniformity of the coatings. While the uncoated alloy exhibited hardness of only 93 HV0.05, a remarkable improvement in hardness to 484 HV0.05 was obtained after 60 min of stannate treatment. High critical load of adhesion (Lc3) of 29 N was also obtained for the same. The stannate layers exhibited coefficient of friction (CoF) of 0.4–0.6 as compared to 0.7–0.8 for bare alloy. The wear loss also notably reduced. In tribo-test, hard and well-adherent coating restricted surface deformation under action of normal load. This in-turn, reduced mechanical engaging at interface, leading to low CoF and wear loss. The dense stannate coating also reduced corrosion rate by 19 times by hindering penetration of corrosive medium. Electroless deposition for 30 min on stannate conversion layer yielded only sporadic growth of Ni-P, which improved to a dense, uniform layer after 60 min of deposition. The Ni-P top coating aided the stannate underlayer in furthering the tribo-mechanical and corrosion characteristics.

A Novel Dual Nickel Coating on Az91d Magnesium Alloy

High Corrosion-Resistance Nanocrystalline Ni Coating on AZ91D Magnesium Alloy

Corrosion resistance of AZ91D magnesium alloy with electroless plating pretreatment and Ni–TiO2 composite coating

Multilayer Ni-P Coating for Improving the Corrosion Resistance of Az91d Magnesium Alloy

Micro-arc Oxidation Behaviors of AZ91D Magnesium Alloy in Different Electrolytes

Microstructure, Friction and Wear Behavior and Corrosion Resistance of electroless Double-Layer Ni-P/Ni-Mo-P Coatings on AZ91D Magnesium Alloy

Electrodeposition of High Corrosion Resistance Cu/Ni–P Coating on AZ91D Magnesium Alloy

Electroless Ni–P deposition plus zinc phosphate coating on AZ91D magnesium alloy

Novel Green and Ecofriendly Route for Fabricating a Robust Corrosion Protection Coating on AZ91D Magnesium Alloy

Preparation and properties of nano ZrO2 coating on magnesium alloy

Direct Electroless Nickel Plating on AZ91D Magnesium Alloy from a Sulfate Solution and Its Deposition Mechanism

Effect of Mg on Al-Mg Alloy and Electroless Ni-P Codeposition of nano-Al2O3: Mechanical, Wear, and Corrosion Resistance Properties

Superhydrophobic Corrosion-Resistant Coating of AZ91D Magnesium Alloy: Preparation and Performance

Analysis of the Causes of Differences between the Upper and Lower Surfaces of Electroless Ni–P Coating on LZ91 Magnesium–Lithium Alloy

Superior corrosion and wear resistance of AZ91D Mg alloy via electrodeposited SiO2–Ni-based composite coating

Wear and Corrosion Resistance of Al0.5CoCrCuFeNi High-Entropy Alloy Coating Deposited on AZ91D Magnesium Alloy by Laser Cladding

Preparation of Conductive and Corrosion Resistant Phosphate Conversion Coating on AZ91D Magnesium Alloy

Environmentally friendly and facile Mg(OH) 2 film for electroless nickel plating on magnesium alloy for enhanced galvanic corrosion inhibition

Corrosion-resistant and superhydrophobic nickel‐phosphorus/nickel/PFDTMS triple-layer coating on magnesium alloy

Enhanced Electrochemical and Tribological Properties of AZ91D Magnesium Alloy via Cold Spraying of Aluminum Alloy

Synthesis and evaluation of tribo-mechanical and corrosion properties of electroless Ni-P coating on AZ91D Mg alloy with stannate conversion underlayer