Abstract:The aerodynamic design and optimization of modern centrifugal compressors are inseparable from computational fluid dynamics (CFD) tools. In a design environment, CFD simulations are expected to predict compressor performance characteristics with reasonable accuracy. Turbulence models and model simplification can play a significant role in the discrepancy between analysis and reality. To investigate the influence of turbulence models on aerodynamic analysis results of centrifugal compressors, the National Aeronautics and Space Administration's high efficiency centrifugal compressor stage is selected as the test vehicle. Six eddy-viscosity models, namely, Spalart–Allmaras (SA), standard k–epsilon (k−ε), renormalization group k–epsilon (RNG k−ε), Wilcox k–omega (k−ω), shear stress transport (SST), and SST-reattachment modification (SST-RM) are considered. In all numerical analyses, measured surface roughness is included with the aim of improving numerical solution accuracy. Although some discrepancies exist, the compressor performance characteristics predicted by the k−ω model are in satisfactory agreement with the test data over the whole speedline. The k−ε model overpredicts the isentropic efficiency than the other models, while the SST-RM model underestimates the total pressure ratio in the near-stall region. The RNG k−ε model matches high flow characteristics but overestimates the choked mass flow rate. The SST model obtains a similar operating range with the test data but underestimates the compressor's isentropic efficiency and total pressure ratio, while the SA model totally overestimates the compressor characteristics due to the wall function. Furthermore, variations caused by turbulence models are discussed together with the flow field analysis. Finally, to verify the impact of the impeller backplate bleed cavity, an additional simulation is conducted that specifically accounts for this feature.

Comparative and validation study of turbulence models for fluidic thrust vectoring nozzle with multiple injection ports

Numerical study on the shock vector control performance in a de Laval nozzle with single or dual injection ports

Numerical Simulation of a Turbulence Flow in the Cut-off Valve by RNG k- ε Turbulence Model

Comparison study of turbulence models in numerical simulation of multi-jets impinging injectors

Validation and Analyses of QCR Correction Turbulence Model in Sub-/Super-sonic Inner Flows

Numerical simulation of 3-D turbulent flows in a cut-off valve and analysis of flow characteristics in pipe

Turbulence Models of Separated Flow in Shock Wave Thrust Vector Nozzle

Influence of the turbulence model on the numerical predictions of cold turbulent flow in a heavy-duty gas turbine DLN combustor

COMPARISON OF EDDY VISCOSITY MODELS FOR HIGH TURBULENCE NGV FLOWS

A Comparison of Various Turbulence Models for Analysis of Fluid Microjet Injection into the Boundary Layer over a Flat Surface

Investigation of turbulence models for aerodynamic analysis of a high-pressure-ratio centrifugal compressor

NUMERICAL INVESTIGATION OF THE THRUST VECTORING PERFORMANCE OF A BYPASS DUAL THROAT NOZZLE

Improved Design and Performance Analysis of Counterflow Thrust Vectoring Technology under High Subsonic.

Research of Comprehensive Modeling of Two-Dimensional Vector Nozzle/Actuator Load/Turbofan Engine

STUDY ON NUMERICAL SIMULATIONS OF A PLUG NOZZLE FOR ROCKET ENGINE

Pangenomic changes induced by DHEA in the skin of postmenopausal women

Aerodynamic Characteristics of the Novel Two-Dimensional Enhanced Shock Vector Nozzle

Modelling Of Impinging Flow And Heat Transfer In A Confined Narrow Gap

Comparative Investigation among Three Cavitation Models for Simulating Cavitating Venturi

Numerical simulation prediction of pressure distribution of guide vanes in a high-head pump turbine

Efforts to Identify the Most Suitable RANS Turbulence Model for Accurate Conjugate Heat Transfer Prediction in Regenerative Cooled Nozzles