Abstract:The internal combustion engine will continue to be the primary source of power for transportation. Spark ignition (SI) engines are still widely used for mobility due to their wide range of operating conditions. The key operating variables of an engine are primarily controlled by an engine control unit that has been calibrated. However, a less accurate sensor can lead to large variations in engine performance and emissions. The purpose of this study was to investigate the importance of air-fuel ratio sensor precision during operation of various engines. In this study, a one-dimensional (1D) computational fluid dynamics (CFD) model was used to analyze the engine response due to the variation of the equivalence ratio sensor precision at different engine speeds and loads, to explore the main indicators influenced by the precision of equivalence ratio measurements, and to propose a discriminant criterion for evaluating the suitability of the proposed equivalence ratio precision in relation to the conversion rate of three-way catalyst and vehicle emissions. The results show that for engine performance, it varies slightly with small changes in the fuel-to-air ratio. At higher engine speeds, a slight change in the air-fuel ratio leads to a smaller change in emissions. At the same time, changes in fuel-to-air ratio have a significant effect on carbon monoxide (CO) and nitrogen oxides (NOx) emissions. Carbon monoxide is the most sensitive to the air-fuel ratio, followed by nitrogen oxides, while unburned hydrocarbons are not sensitive to it. And for the three measurement accuracies studied in this paper (0.5%, 1%, and 2%), the accuracies are acceptable, but combining the relative errors of the actual emissions of CO and in order to achieve accurate combustion control, it is recommended that the sensor accuracy should be at least higher than 1% for the port fuel injected engine investigated in this study.

Research Trend of New Aero-Engine Measurement Sensors

Design and Research of Electrostatic Sensor Based on Aero-engine Airway Electrostatic Monitoring Technology

Development of High Temperature Gas Sensor Technology

Advances in the application of non-contact temperature measurement technology for aero-engine blade.

Characters of Sensor for Aero-Engine Gas Path Electrostatic Monitoring

Data-Driven Equivalent Space Aero-Engine Sensor Robust Fault Diagnosis

Temperature and heat flux measurement technologies in scramjet

Numerical Investigation of the Fuel/Air Ratio Sensor Sensitivity in a Port-Fuel-Injected Spark-Ignition Engine Equipped with Three-Way Catalysts

Investigation of Aeroengine On-Line Fault Diagnosis System Based on Dual-Channel Sensor Measurements

Design of Sensor Channels Adjusting System for an Aero-engine

Opportunities and challenges of MEMS technology in the environment of intelligent aero-engines

Aeroengine's Fault Detection Technology Based on Image Automatic Measurement

Research on Tip Clearance Measurement Technology of Aero-engine Blade Based on Optical Fiber Sensing System

Development Trend or Fuel Measuremeet System or Civil Aircraft

Development trend of aeroengine automatic measurement and control system

Advances in Thin Film Sensor Technologies for Engine Applications

Performance Comparison of Three Fibre-Based Reflective Optical Sensors for Aero Engine Monitorization

Advances in application of contact temperature measurement technology for aero-engine blade

A Review Of Aero-Engine Turbine Blade Temperature Measurement

Entropy-based Sensor Selection for Condition Monitoring and Prognostics of Aircraft Engine

Monitoring Aero-engine Gas Path with Electrostatic Sensors