Abstract:Sludge reduction is essential for mitigating the environmental hazards associated with sludge. The use of ferric chloride (Fe(III)) catalyzed ferrate (Fe(VI)) can significantly enhance sludge dewaterability by increasing the Fe(VI) oxidation rate and maintaining in-situ enhanced coagulation. However, its weak oxidation ability at the sludge’s original pH limits its practical application. To address this, hydrogen peroxide (H2O2) strengthened Fe(VI)/Fe(III) was employed to efficiently improve sludge dewaterability without pH adjustment, thereby enhancing the environmental utilization capacity of sludge. Compared to raw sludge, the treatment of Fe(VI)/Fe(III)–H2O2 resulted in approximately the 95% reduction in specific resistance to filtration (SRF) and increased the bioavailable phosphorus (P) content in dewatered sludge. During the oxidation process, highly reactive species such as tetravalent iron (Fe(IV)) and hydroxyl radicals (OH) were generated, facilitating the release of tightly bound water in extracellular polymeric substances (EPS). Importantly, the oxidation process was divided into three stages (persistent moderate oxidation — fast strong oxidation — sustained weak oxidation) based on the predominant reactive species (Fe(IV) or OH). This division promoted more robust and more durable oxidation processes. Phased enhanced coagulation occurred during the oxidation process. The gradual increase in Fe(III) content led to the re-flocculation of damaged EPS, enlarging the size of sludge drainage pores/channels and improving water discharge efficiency. Additionally, the costs and carbon emissions of chemicals for the Fe(VI)/Fe(III)–H2O2 process were 18% and 52% lower than those of the traditional Fenton method. This study not only achieves the goals of sludge reduction and resource collection but also provides insights into selecting sludge conditioning methods that meet pollution reduction and carbon emission reduction requirements.

Decoloration of Swill Oil

DECOLORING OF DYESTUFFS AND DYING WASTE WATER WITH IMMOBILIZED MYCELIAL PELLETS OF Coriolus versicolor

Bleaching with the Mixed Adsorbents of Activated Earth and Activated Alumina to Reduce Color and Oxidation Products of Anchovy Oil

Decoloration of dye wastewater using sludge carbon supported iron catalytic persulfate and ozone oxidation

Sludge Treatment by O-3/H2o2 and Carbon Source Recovery

Deep Dewatering of Refinery Oily Sludge by Fenton Oxidation and Its Potential Influence on the Upgrading of Oil Phase

Technical Grade Polyethylene Glycol Solution Decolorization Research

Decolorization of Soybean Oligosaccharides from Waste Sweet Slurry in Soybean Sheet Production

Treatment of Flax Dyeing Wastewater by UV/ferrioxalate/H2O2 System

Decolorization and Mineralization of Acid Orange Ⅱ by NaClO Oxidation

Decoloration and Mineralization of Anthraquinone Dye Reactive Blue KN-R by NaClO Chemical Oxidation

Refining Waste Fried Oil through Sodium Silicate and Activated Bleaching Clay

Study on Decoloration Technology of Biodiesel Catalysed by Homogeneous Acid

Synthesis of Green Plasticizers from Swill-Cooked Dirty Oil Catalyzed by Ion Exchange Resin

Refining of waste cooking oil with sodium silicate and activated bleaching earth

Influence of Fenton Oxidation on the Dewaterability of Textile Dyeing Sludge

Wet Oxidation of Pharmaceutical Sludge for the Treatment and Production of Value-Added Materials

Experimental study on supercritical water oxidation of oily sludge with auxiliary fuels

Advanced Treatment of the Effluent from Washing/Bleaching Plants of the Straw Pulp Mill

Degradation of Azo Dye by Three Clean Advanced Oxidation Processes : Wet Oxidation, Electrochemical Oxidation and Wet Electrochemical Oxidation-a Comparative Study

A Three-Stage Oxidation Method Improves Sludge Dewaterability by Achieving Sustained Oxidation and Phased Enhanced Coagulation: Ingeniously Using H2O2 As a “Converter”