Abstract:In this study, we examined the thermal effects throughout the process of the placement of span-scale girder segments on a 6×110-m continuous steel box girder in the Hong Kong-Zhuhai-Macao Bridge. Firstly, when a span-scale girder segment is temporarily stored in the open air, temperature gradients will significantly increase the maximum reaction force on temporary supports and cause local buckling at the bottom of the girder segment. Secondly, due to the temperature difference of the girder segments before and after girth-welding, some residual thermal deflections will appear on the girder segments because the boundary conditions of the structure are changed by the girth-welding. Thirdly, the thermal expansion and thermal bending of girder segments will cause movement and rotation of bearings, which must be considered in setting bearings. We propose control measures for these problems based on finite element method simulation with field-measured temperatures. The local buckling during open-air storage can be avoided by reasonably determining the appropriate positions of temporary supports using analysis of overall and local stresses. The residual thermal deflections can be overcome by performing girth-welding during a period when the vertical temperature difference of the girder is within 1 °C, such as after 22:00. Some formulas are proposed to determine the pre-set distances for bearings, in which the movement and rotation of the bearings due to dead loads and thermal loads are considered. Finally, the feasibility of these control measures in the placement of span-scale girder segments on a real continuous girder was verified: no local buckling was observed during open-air storage; the residual thermal deflections after girth-welding were controlled within 5 mm and the residual pre-set distances of bearings when the whole continuous girder reached its design state were controlled within 20 mm.

Effect of Segmental Joints on Structural Deformation in Long-span Prestressed Concrete Box Girders

Control Measures for Thermal Effects During Placement of Span-Scale Girder Segments on Continuous Steel Box Girder Bridges

The anti-arch inhibition effect of multispan continuous girder bridge strengthened with prestressed CFRP plates

Simulation Analysis of Girder Transport Process on the Box Girder of Hangzhou Bay Bridge

Mechanical Behavior of Box Girder Bridge with Partial Corrugated Steel Webs

Research on Rational Post Successive Prestress Tension Sequence of Simply Supported and Continuous Box Girder Bridge

Time-dependent behavior of PC box girder bridges considering non-uniform shrinkage and creep

Simulating analysis of cantilever casting of prestressed concrete bridge

Influence of Effective Prestress on Ultimate Bearing Capacity for Large-Span Prestressed Concrete Bridge

Influence analysis of group studs stiffness in accelerated construction steel-concrete composite small box girder bridges

Study on the Effect of Middle Diaphragm on Ultimate Loading Capacity of Multi-Box Girder Bridges

Spatial Simulating Analysis Of Prestressing Force Effect Of Long Span Prestressed Concrete Box Girder Bridge

Flexural Behavior of Precast Concrete Segmental Box-Girders with Dry Joints

Experimental Study on Failure Mode of Precast Assembled Segmental Beams under Impact Loading

SIMULATION FOR CONSTRUCTION PROCESS OF P.C. CONTINUOUS RIGID FRAME BRIDGE

Influence of effect of creeping of the long span prestressed concrete cable-stayed bridge on internal forces in structural health monitoring

Time-dependant effects on curved precast segmentally constructed balanced cantilever bridges

Finite element analysis of temporary pre-stress system of precast segmental box girder bridge

Fatigue Performance of a Novel Steel–Concrete Joint of a Long-Span High-Speed Railway Hybrid Girder–Cable-Stayed Bridge

Experimental and numerical study of steel-to-concrete joint section in hybrid cable-stayed bridges

Experimental study on the shear behavior of precast concrete segmental simply supported beam with internal tendons and glue joints