Abstract:Tube overheating is the leading cause of boiler tube failures that had led to tremendous replacement and maintenance costs. Boiler tube temperature is simultaneously affected by the heating effect of hot combustion gas in the furnace and the cooling effect of steam flow in boiler tubes. Thus, prediction of tube temperature needs to include the simulations of both the gas and steam flows of the boiler in the model. To compromise the significant scale difference between the boiler furnace and tubes, a coupled model that integrates a three-dimensional (3D) CFD model describing the gas flow and combustion processes in the furnace with a one-dimensional (1D) hydrodynamic model describing the steam flow in the boiler waterwall tubes was developed in this paper. The 3D CFD and 1D hydrodynamic models are coupled by iterative data exchange of boiler heat flux and steam temperature between the two models. In this way, this coupled model can incorporate all the key parameters that strongly affect the waterwall tube temperature, including the distributions of boiler heat flux, steam temperature and the convective heat transfer coefficient of steam flow in boiler tubes. In particular, the critical effects of steam maldistribution caused by both the structure of tube network system and uneven heat absorption of parallel tubes on tube temperature can be resolved by this model. This coupled model provides the capability to predict the detailed distribution of waterwall tube temperature and locate the areas of tube overheating under different boiler operating parameters. This coupled model was employed to predict the tube temperature distribution of the spiral waterwall of a 350 MW supercritical boiler. The predicted results show that the areas having higher risk of tube overheating are located near the outlet of spiral waterwall tubes where the steam temperature is the highest and on the wall areas where the local wall heat flux is the highest. The results strengthen the necessity of incorporating both the gas and steam sides of boiler into the model for accurate prediction of waterwall tube temperature.

Numerical modeling and analysis of thermal deflection for the overheater of supercharge boiler

Analysis of Superheater’s Pipe Wall Overtemperature by Fault Tree Diagnose

Numerical simulation analysis of a heat transfer tube in SuperORV

General numerical method for hydraulic and thermal modelling of the steam superheaters

NUMERICAL MODELING OF 3-D ISOTHERMAL FLOW IN TANGENTIALLY-FIRED BOILER WITH BODY-FITTED MESHES

Numerical Simulation of Heat Transfer in Finned Tube of Heat Recovery Unit Using Fluid-Solid Coupled Method

Numerical Investigation of Heat Transfer to Supercritical Pressure Water in Vertical Tube with Non-Uniform Heating Form

Numerical Investigation On The Heat Transfer Enhancement Behavior Outside Longitudinal Finned Tubes

Integrated Numerical Model for Ultra/Supercritical CFB Boilers

A coupled combustion and hydrodynamic model for the prediction of waterwall tube overheating of supercritical boiler

Numerical study of heat transfer and pressure drop characteristics in helical tubes based on OpenFOAM

Numerical Analysis on Heat Transfer Characteristics and Buoyancy Effects of Supercritical Pressure Water in Vertical Tube

Computational Analysis of Tube Wall Temperature of Superheater in 1000 MW Ultra-Supercritical Boiler Based on the Inlet Thermal Deviation

Dynamic Behavior of Steam Temperature of Supercritical Thermal Power Units

Numerical study on the complicated flow filed of steam turbine condenser throat

Numerical Simulation in a Supercirtical CFB Boiler

Prediction of tube temperature distribution of boiler platen superheater by a coupled combustion and hydrodynamic model

Investigation And Modeling Of The In-Tube Heat Transfer Of Fluids At Supercritical Pressure During Heating

Numerical study on natural convection heat transfer of fin-tube air-heating vaporizer

Numerical study on heat transfer characteris tics of supercritical water in straight and helical tubes

Research on fluid flow and heat transfer characteristics in a three-dimensional condenser