Abstract:Black liquor is a byproduct from the production of pulp and paper. Since Sweden to a large extent consists of forest it would be of great interest to use this byproduct for manufacturing of other products. Black liquor contains lignin and hemicelluloses which could be used for production of biofuel and plastics respectively. To separate these components from the black liquor, membrane filtration with ceramic membranes can be used. This study compares the efficiency of separation between ultrafiltration (UF) and nanofiltration (NF) with ultrafiltration as a pre-treatment. The results showed that a good separation of lignin and hemicelluloses from black liquor could be achieved with both methods. However, if a separation between lignin and hemicelluloses was the aim, ultrafiltration as a first step is required. The initial flux during NF increased almost 100 % (from 200 l/m 2 h to approximately 400 l/m 2 h) when the feed was permeate from ultrafiltration instead of untreated black liquor. The higher flux made it possible to reach a higher volume reduction which is desired. The results of the study show that separation of lignin and hemicellulose from black liquor is possible and that ultrafiltration as a pre-treatment has advantages compared to nanofiltration alone. Key-words: Nanofiltration, black liquor, membrane, lignin, hemicelluloses Introduction The energy demand of the world is increasing daily and today 30 % of the consumed energy is derived from fossil fuels such as oil, coal and natural gas [1]. Since the resources of these fuels will come to an end and the prices are increasing, it is important to find renewable, cheaper energy sources to meet the increasing demand [1]. Sweden is a country that is, to a large extent, covered in forest. Consequently, products from the forest industry equal 11 % of the total value of exported goods [2]. From the forest the most used raw material is wood and the largest part of the industry itself is the production of pulp and paper [3]. In the making of pulp, the wood is debarked and chopped and then fed to a digester [4]. Here, chemicals are added at a high temperature to separate the fibers from other components of the wood such as lignin, hemicelluloses and extractives [4]. From the digester two streams are obtained, of which one is rich in fibers. This stream is later washed, bleached and dried to get pulp. The other stream is black liquor [4], which is sent to a recovery boiler where the cooking chemicals are regenerated and the organic material is burnt to produce heat and power [5]. Since black liquor contains both hemicellulose and lignin which could be used to produce plastics and biofuels, a separation of this two components from the black liquor would be of interest [6]. The purpose of this study was to separate lignin and hemicelluloses from the black liquor by using membrane filtration. Materials and method Black liquor The black liquor used in this project was softwood black liquor from Södra Cell pulp mill in Mönsterås, Sweden. It was extracted directly after the digester and thus no chemicals for bleaching have been added. The composition of the black liquor used is presented in table 1. Table 1 Composition of the black liquor used. Total lignin 61,4 mg/g Acid-insoluble lignin 53,9 mg/g Acid-soluble lignin 5,03 mg/g Total dry substance 147 mg/g

Isolation and characterization of lignin in black liquor

Structure-property Relationships for Technical Lignins for the Production of Lignin-Phenol-formaldehyde Resins

Structural Characterization of Lignins from Willow Bark and Wood.

Evaluation of Organosolv Pretreatment on the Structural Characteristics of Lignin Polymers and Follow-Up Enzymatic Hydrolysis of the Substrates from Eucalyptus Wood.

Precipitation and separation of lignin from kraft black liquor

Characterization of Ligninolytic Bacteria and Analysis of Alkali-Lignin Biodegradation Products

Comparing Physicochemical Characteristics and Depolymerization Behaviors of Lignins Derived from Different Pretreatment Processes

Characterization of isolated lignin from eucalyptus wood chip obtained by liquid hot water process

Separation and Characterization of Pyrolytic Lignins from the Heavy Fraction of Bio-Oil by Molecular Distillation

Evaluation of pyrolysis characteristics and product distribution of black liquor using Py-GC/MS and down tube reactor: Comparison with lignin

Bacterial Transformation of Aromatic Monomers in Softwood Black Liquor

Physical and Chemical Properties of Acacia mangium Lignin Isolated from Pulp Mill Byproduct for Potential Application in Wood Composites

Characterization of Pyrolytic Lignins with Different Activities Obtained from Bio-Oil

Characteristics of black liquor after alkaline delignification of paulownia wood

Lignin recovery from spent alkaline pulping liquors using acidification, membrane separation, and related processing steps: A review

Fractionation and quantitative structural analysis of lignin from a lignocellulosic biorefinery process by gradient acid precipitation

The Impact of Sulfur-Containing Inorganic Compounds during the Depolymerization of Lignin by Hydrothermal Liquefaction of Black Liquor

Effects of partial lignin extraction on rheological characteristics and combustion performance of high solids bamboo kraft black liquor

Microwave-assisted depolymerization of lignin and a biphasic extraction method for the recovery of bio-oil and phenolic monomers

Lignin with controlled structural properties by N-heterocycle-based deep eutectic solvent extraction

Separation of lignin and hemicelluloses from black liquor and pretreated black liquor by nanofiltration