Abstract:Real-time motion tracking of kinematic chains is a key prerequisite in the control of, e.g., robotic actuators and autonomous vehicles and also has numerous biomechanical applications. In recent years, it has been shown that, by placing inertial sensors on segments that are connected by rotational joints, the motion of that kinematic chain can be tracked accurately. These methods specifically avoid using magnetometer measurements, which are known to be unreliable since the magnetic field at the different sensor locations is typically different. They rely on the assumption that the motion of the kinematic chain is sufficiently rich to assure observability of the relative pose. However, a formal investigation of this crucial requirement has not yet been presented, and no specific conditions for observability have so far been given. In this work, we present an observability analysis and show that the relative pose of the body segments is indeed observable under a very mild condition on the motion. We support our results by simulation studies, in which we employ a state estimator that neither uses magnetometer measurements nor additional sensors and does not impose assumptions on the accelerometer to measure only the direction of gravity, nor on the range of motion or degrees of freedom of the joints. We investigate the effect of the amount of excitation and of stationary periods in the data on the accuracy of the estimates. We then use experimental data from two mechanical joints as well as from a human gait experiment to validate the observability criterion in practice and to show that small excitation levels are sufficient for obtaining accurate estimates even in the presence of time periods during which the motion is not observable.

Identification of Isomorphism among Kinematic Chains and Inversions Using Link's Adjacent-Chain-table

Improved high-order adjacent vertex assignment sequence for similarity vertices and isomorphism identification of planar kinematic chains

A Generalization of Kempe’s Linkages

Planar Closed Loop Double Chain Linkages

Isomorphism Detection of Kinematic Chains Based on the Improved Circuit Simulation Method

On the Virtual Joints for Kinematic Control of Redundant Manipulators with Multiple Constraints

A novel graphical joint-joint adjacent matrix method for the automatic sketching of kinematic chains with multiple joints

Automatic Structural Synthesis of Planar Multiple Joint Kinematic Chains

Recognition of Motion-independence Chain for Virtual Prototyping

Novel inverse kinematic approaches for robot manipulators with Pieper-Criterion based geometry

Generation Of Planar Kinematic Chains With One Multiple Joint

Kinematic and Dynamic Models of Hyper-Redundant Manipulator Based on Link Eigenvectors

General program of kinematic analysis of planar linkage

On the Configurations of Closed Kinematic Chains in three-dimensional Space

Improved Inverse Kinematics Algorithm Using Screw Theory for a Six-DOF Robot Manipulator

The Design of Kinematic Chains Based on the Principle of Invariable Terminal Constraints

Kinegami: Algorithmic Design of Compliant Kinematic Chains From Tubular Origami

Intrinsically Multi-Stable Spatial Linkages

Analysis of Instantaneous Kinematic Properties regarding the Shape of Robotic Mechanisms

Observability of the relative motion from inertial data in kinematic chains

Two model-free schemes for solving kinematic tracking control of redundant manipulators using CMAC networks