Frictional Behavior of the Stressed Basalt Fracture
Lei Wang,Zhen Zhong,Yunjin Hu,Jianhang Ding
DOI: https://doi.org/10.1088/1755-1315/861/5/052003
2021-01-01
IOP Conference Series Earth and Environmental Science
Abstract:The frictional properties and sliding stability of rocks are critically important in several fields, e.g., earthquake dynamics, extraction of underground resources, and sequestration of carbon dioxide. Here a self-developed triaxial apparatus was employed to conduct sliding tests under the coupled hydro-mechanical (HM) conditions. We determined the evolution of frictional strength in the stressed basalt fracture. The relations were established through velocity-stepping (VS) experiments on split basalt core subject to various stress, infill, and hydraulic conditions. The basalt exhibited velocity-strengthening behavior under cyclic velocities of 1–30 μm/s. Moreover, the frictional property was observed to be stress- and infill-dependent, showing lower frictions at both larger effective normal stresses and larger infill thickness. Besides, the sliding stability of the basalt fracture is found to be velocity- and stress-dependent. In particular, an unstable slip of a stick-slip was observed at a small velocity of 1 μm/s, but stabilizes with increasing shearing velocities at about 6 μm/s. Meanwhile, there is a transition from stable slip to unstable slip with the increasing effective normal stress, which is 5 MPa. Whereas, the thickness of the gouge as large as 2 mm does not seem to influence the sliding stability, even though the gouge thickness will significantly weaken the frictional strength of basalt fracture. The results suggested that the evolution of basalt fracture friction is controlled considerably by hydro-mechanical conditions, the sliding velocity, and gouge thickness. The frictional strength tends to vary with specified hydraulic, mechanical, gouge-bearing conditions. Furthermore, the frictional behavior transits between stable- and unstable-slip based on the velocities, stress pore pressure, and gouge thickness. These conclusions are drawn from constrained conditions.