Abstract:Abstract The unsupported catalysts were obtained during hydrogenation by in situ high-temperature decomposition (above 300 °C) of water-soluble metal precursors (ammonium molybdate and nickel nitrate) in water-in-oil (W/O) emulsions stabilized by surfactant (SPAN-80) using elemental sulfur as sulfiding agent. These self-assembly Ni–Mo sulfide nanosized catalysts were tested in hydrogenation of aromatics under CO pressure in water-containing media for hydrogen generation through a water gas shift reaction (WGSR). The composition of the catalysts was determined by XRF and active sulfide phase was revealed by XRD, TEM and XPS techniques. The calculations based on TEM and XPS data showed that the catalysts are highly dispersed. The surfactant was found to affect both dispersion and metal distribution for Ni and Mo species, providing shorter slab length in terms of sulfide particle formation and stacking within high content of NiMoS phase. Catalytic evaluation in hydrogenation of aromatics was performed in a high-pressure batch reactor at T = 380–420 °С, p(CO) = 5 MPa with water content of 20 wt.% and CO/H 2 O molar ratio of 1.8 for 4–8 h. As shown experimentally with unsupported Ni–Mo sulfide catalysts, the activity of aromatic rings depends on the substituent therein and decreases as follows: anthracene>>1-methylnaphthalene≈2-methylnaphthalene>1,8-dimethylnaphthale-ne>>1,3-di-methylnaphthalene>2,6-dimethylnaphthalene≈2,3-dimethylnaphthalene>2-ethyl-naphthalene. The anthracene conversion reaches up to 97–100% for 4 h over the whole temperature range, while for 1MN and 2MN it doesn’t exceed 92 and 86% respectively even at 420 °С for 8 h. Among dimethyl-substituted aromatics the higher conversion of 45% was achieved for 1,8-dimethylnaphthalene with 100% selectivity to tetralines at 400 °С for 6 h. Similar to 1- and 2-methylnaphtalenes, the hydrogenation of asymmetric dimethyl-substituted substrate carries out through the unsubstituted aromatic ring indicating that steric factors influence on the sorption mechanism over active metal sites. The catalysts were found to be reused for at least six cycles when the hydrogenation is sulfur-assisted preventing metal oxide formation. It was established, that at the first 2–3 h known as the induction period, the oxide catalyst precursors formed slowly by metal salt decomposition, which reveals that it is the rate-determining step. The sulfidation is rather fast based on high catalytic activity data on 2MN conversion retaining at 93–95% upon recycling.

A novel Ni<sub>2</sub>Mo<sub>3</sub>N/MCM41 catalyst for the hydrogenation of aromatics

Study on the Ni Supported Catalysts Used for Hydrogenation of IPN to Produce MXDA

Synthesis of Novel NiMo Catalysts Supported on Highly Ordered TiO2-Al2O3 Composites and Their Superior Catalytic Performance for 4,6-Dimethyldibenzothiophene Hydrodesulfurization

HYDROGENATION PROPERTIES OF Mo-Ni-P CATALYST ON MCM-41 SUPPORTED

Synthesis of Ni/Mo/N Catalyst and Its Application in Benzene Hydrogenation in the Presence of Thiophene

Nanostructured Ni-MoCx: An efficient non-noble metal catalyst for the chemoselective hydrogenation of nitroaromatics

MoO x regulating Ni-based catalyst anchored on N-doped carbon microspheres for catalytic hydrogenation of nitroarenes

Catalytic Hydropyrolysis of Lignin Using NiMo-doped Catalysts: Catalyst Evaluation and Mechanism Analysis

Comparative Study on the Hydrogenation of Naphthalene over Both Al2O3-Supported Pd and NiMo Catalysts against a Novel LDH-Derived Ni-MMO-Supported Mo Catalyst

Promotion of Ni/MCM-41 Catalyst for Hydrogenation of Naphthalene by Co-Impregnation with Polyols

Influence of Ni on the active phase and hydrodenitrogenation and hydrodesulfurization activities of MoS2 catalysts

Hydrogenation of Aromatics from Low Temperature Coal Tar over Novel Mesoporous NiMoC/Hβ Catalysts

Hydrodesulfurization of Thiophene on Ni, Mo-Supported Mcm-41 Catalysts

Morphological and Heterojunctional Engineering of Two-Dimensional Porous Mo-Ni Based Catalysts for Highly Effective Catalytic Reduction of Aromatic Nitro Compounds

Structure-performance Relationship of NiMo/Al2O3-HY Catalysts in Selective Hydrocracking of Poly-Aromatics to Mono-Aromatics

A Study on the Role of Ni Atoms in the HDN Activity of NiMoS2/Al2O3 Catalyst

Ni–Mo sulfide nanosized catalysts from water-soluble precursors for hydrogenation of aromatics under water gas shift conditions

The Reaction Performance and Surface Character of Ni Modified Mo/Hzsm-5 Catalyst for Methane Aromatization

Oil-soluble Ni-Mo Sulfide Nanoparticles and Their Hydrogenation Catalytic Properties

Noble-metal-free Ni<sub>10</sub>MoCo<sub><i>x</i></sub>/Mo–Ni–O as an active and durable catalyst for hydrogen generation from hydrazine monohydrate

Bimodal mesoporous AlMCM-41 supported NiMo catalysts for efficient hydrodesulfurization of 4,6-dimethyldibenzothiophene